Electronics Forum | Mon Jan 28 13:58:41 EST 2019 | oxygensmd
1. switch the axis cards 2. switch the axis servo cards 3. make sure the distance between scale and encoder is 400um 4. check the signal by oscilloscope, adjust to have the right signal 5. replace the scale or encoder
Electronics Forum | Wed Mar 02 05:02:46 EST 2005 | prabhu_jude
Hello, We are using a film piezo electric sensor to deduct and measure vibrations. A long twisted pair shielded cable is used to connect the sensor to the signal conditioning unit (the signal conditioning unit has to be kept at a distance from the se
Electronics Forum | Wed Mar 02 05:06:15 EST 2005 | prabhu_jude
Hello, We are using a film piezo electric sensor to deduct and measure vibrations. A long twisted pair shielded cable is used to connect the sensor to the signal conditioning unit (the signal conditioning unit has to be kept at a distance from the se
Electronics Forum | Tue Jan 07 02:04:45 EST 2020 | robl
Hi Mikey, Your signal pins (2 & 3) for USB1, 2, & 3 are all connected together so there is no way of splitting the incoming signals from the 3 ports. Normally there would be an IC (a USB hub controller) switching between the signals so that the PC
Electronics Forum | Tue Dec 01 20:50:51 EST 2020 | tueftler
Hi there. Thank you for your reply. I have tested the VGA signal with two different VGA to VGA & HDMI converters without success. Now i have connect my oscilloscope onto the signal. RGB,V and Hsync...no signal at all after WinXP boot cycle. If i
Electronics Forum | Wed Apr 24 14:14:57 EDT 2002 | stefwitt
If nobody else can help you and you are not afraid to add a bit of hardware, I would like to give it a try. If pistons are air activated there should be a solenoid for each piston. Locate the I/O signals, wire in a double through switch and apply 24
Electronics Forum | Tue Mar 27 14:08:12 EDT 2007 | diesel_1t
Nobody??? Regards.
Electronics Forum | Wed Apr 11 18:46:06 EDT 2007 | darby
Excellent reply. You have my sympathies. Good luck!
Electronics Forum | Wed Apr 11 19:06:59 EDT 2007 | diesel_1t
Seems to be easy and effective, I will ask for further information with them... Regards
Electronics Forum | Fri Feb 29 09:28:56 EST 2008 | chrispink1
Anybody know what the connections are, and signalling requirements for fuji nxt feeders