Electronics Forum | Fri Jun 26 14:20:54 EDT 2020 | victorzubashev
Great news that you have progress Lazslo! I was sure that the problem you described - is a hardware issue and not Software (MC, SR ...). regarding" pinole of" do you mean sleeves? Please send me an email, so I can help you. victor.zubashev@qbotech.
Electronics Forum | Mon Mar 16 12:10:59 EDT 2020 | emeto
Katrina, it is one of both: 1. Communication error - try to initialize machine with line controller OFF. This should tell you if machine can initialize on its own and if the problem is on the machine. Try without the feeder carts, look at the cards
Electronics Forum | Mon Aug 05 09:16:39 EDT 2013 | valeriusx
Greetings. I'm having some difficulties in configuring 2 old SIPLACE Placement Machines - 80S-15 and 80F-3. They are already installed, there are no errors on machines computers, but I can't configure connection between these machines and the line c
Electronics Forum | Tue Jan 26 12:15:45 EST 2016 | mjscottinnc
We recently purchased a used HS50 and we are trying to get it up and running. We are completely new to SiPlace and I have a few questions about terminology. Machine Computer, Station Computer, and Line Computer. There appear to be two computers in th
Electronics Forum | Thu Nov 13 06:00:24 EST 2003 | stefwitt
The Siplace web-site will not help you very much, because the HS 180 does not belong to the Siplace line. All the older Siemens machines operate with HP Basic and the computer hardware can't even be replaced with DOS based PC's. Dependent what type
Electronics Forum | Sun Oct 04 08:07:53 EDT 1998 | jvo
| I am experiencing solder paste comtaminatin of nozzels on 0603 size components resulting in missing components. The machine is failing to alarm under these circumstances. Has anybody else experienced this problem & found a solution? | Check if you
Electronics Forum | Mon Feb 19 20:43:57 EST 2024 | erici
Thanks again for the reply. I did what you mentioned on your previous message. When i rebooted the machine i came up with a "software booting" message and didn't go past that. I checked the MC and i got the error "no SRBS, system halted". What is S
Electronics Forum | Fri Nov 20 10:44:46 EST 2015 | cgreiner
Hello > > I got a SiPlace 80-S20 machine which had > a damaged hard drive in MC. I changed HDD and > re-installed RMOS + MC from floppies. Then I > turned on the machine (without any Line > Computer). > > The software on Station computer > wou
Electronics Forum | Wed Sep 10 07:42:52 EDT 2008 | lloyd
Can you provide a bit more info on your machine setup. I not full fimilar with the S-27 so a few points may not be relevant to your machine. Are you using Siplace Pro. Are you using the standard GF for the 0201 component. Do you have the component
Electronics Forum | Thu Mar 05 23:04:44 EST 2020 | sarason
My advice for what it is worth. Your description of the problem at first glance suggests a communication problem, now is it the bus, the SMT machine or the PC. The bus could have a short or an open. The PC could have a dud controller card. or so co