Electronics Forum | Wed Feb 16 09:19:22 EST 2000 | MARK ALDER
Please check Circuit Assembly March 1998, article "Solder balls and aperture shapes" and August 1999 "Guiding stencil design". They can be contacted at www.circuitassembly.com The main cause of mid chip solder balls is the volume of paste that is p
Electronics Forum | Tue Mar 23 20:55:00 EST 2004 | Dreamsniper
First Time to solder BGA's using Water Soluble. We are currently using an Aquaeous Cleaner to clean our PCB's but I find it not enough to clean the flux from under our BGA's. Has anyone had this experience before that he may like to share how he mana
Electronics Forum | Wed Jun 24 23:52:41 EDT 1998 | Phillip Hunter
| Has anyone seen a problem with solder under chip components, in-between the glue and the component or in-between the mask and the component? We seen both. | What could be causing this? This has only been detected on one of our products. All the re
Electronics Forum | Thu Apr 11 19:06:59 EDT 2002 | tmarc
We are using 1mm pitch BGAs with a great quantity of via(s) under the component. Very shortly we will be placing CSPs with .65mm pitch. Our via(s) are solder masked, however we generally have a percentage of them that the masking is thin enough that
Electronics Forum | Tue May 15 21:57:06 EDT 2001 | davef
Welcome!!! Where the hay ya been??? Sorry bud, were lining-up with your fab [it hurts me to say that, but when yer ] We used to dry pack with desiccants, also. Its probably an old MIL-STD-2073-1C requirement [er something like that]. We qui
Electronics Forum | Wed Feb 08 09:43:08 EST 2023 | charles_nguyen
Thank you for the above information but what I want to talk about is the PCB design aspect. Should there be any warning about it in the DFM?
Electronics Forum | Wed Oct 17 12:05:08 EDT 2018 | charliedci
We had a selective solder installation tech raise the connector body off of the PCB slightly with a spacer to allow for a visual inspection to verify the process/profile. A few years back we invested in a large enclosure X-ray with a manipulator arm
Electronics Forum | Sun Apr 05 09:46:47 EDT 1998 | Earl Moon
| We are looking at reflow soldering some Flexi-rigid | pcbs. I have heard that IR reflow soldering can make the Polyimide "self heat" and cause de-lamination. | Does anyone have any info. The thermal problems associated with polyimide rigid/flex de
Electronics Forum | Tue Feb 03 10:10:27 EST 2009 | milroy
Hi, There is one thing missing still, you must put a TC from the bottom side of the BGA by making a hold on the test board at the TC can measure the temperature at exactly the middle of the BGA. You should be able to the dual time and peak temperatu
Electronics Forum | Mon Aug 16 07:54:05 EDT 1999 | Peter Barton
| | | | One of the DFM suggestions I've seen is to remove the solder mask web, i.e. the mask between pads on 20-mil QFP devices. The rational is that if the mask is thicker than the pad the mask can prevent the stencil from making intimate contact w
Products, services, training & consulting for the assembly, rework & repair of electronic assemblies. BGA process experts. Manufacturers Rep, Distributor & Service Provider for Seamark/Zhuomao and Shuttle Star BGA Rework Stations.
Training Provider / Manufacturer's Representative / Equipment Dealer / Broker / Auctions / Consultant / Service Provider
1750 Mitchell Ave.
Oroville, CA USA
Phone: (888) 406-2830
.gif)
