Electronics Forum | Tue Jun 20 16:41:12 EDT 2017 | kkrestchmer
We have a Speedline Electrovert Bravo 8 reflow oven. We have issues where we get a "thermal runaway HTSC trip" error and the oven shuts down. We normally can unplug and replug a connector into the Sensor/Relay Watlow AnaFaze TLM-8 module and it sta
Electronics Forum | Fri Jun 23 12:21:29 EDT 2017 | rgduval
I'm going to guess that you've tried Speedline with no success. They're awfully annoying about their older machines. Things to check: - Thermistor for the zone working properly? - Opto for the zone working correctly? - Heaters working correctly? -
Electronics Forum | Sat Jul 01 00:20:08 EDT 2017 | aemery
Kelly, it's been a long while since I repaired a BRAVO. The machine was a little unique as far as Electrovert ovens go. I am pretty sure that it is the only Speedline model that integrated a PLC. Loved the OMNI's, not so much with the Bravos. I a
Electronics Forum | Thu Jul 18 04:42:32 EDT 2013 | ericrr
Thanks for that, sorry Im late setting (set by someone else) Speedline Bravo Top 1st chamber, 2nd, 3rd, 4th. 170° (c), 180°, 190°, 270°. Bottom 170°, 180°, 180°, 260° chain speed 27cm/second.
Electronics Forum | Fri Jan 23 15:57:12 EST 2015 | rgduval
Anyone out there have one of these Electrovert/Speedline ovens? Our PLC lost its mind, and we're looking to get it back. Speedline doesn't support the oven anymore, so, getting the file out of them doesn't seem likely. The PLC is Mitsubishi FX2N48
Electronics Forum | Fri Jun 26 10:33:08 EDT 2015 | Asif
Hello Professionals, Good morning, We are circuit card manufacturer for the Aerospace industry with low volume and High mix level. We have a plan to Purchase a NEW REFLOW OVEN. Currently we are using Electrovert BRAVO reflow oven which is about 8 yea
