Electronics Forum | Fri Jan 13 23:07:02 EST 2006 | JimS
Call 1-573-346-3341. The Tech. support guys will be able to help.I do not remember the 800 number. These days with cell phones and free muintes why bother. Hope this helps.
Electronics Forum | Sun Jan 15 15:17:28 EST 2006 | dwaters12
the toll free tech line ph.# is 1-800-737-8110 then just follow the menu
Electronics Forum | Mon May 14 08:53:42 EDT 2007 | realchunks
Can't do much better than Electrovert. http://cgi.ebay.com/SPEEDLINE-ELECTROVERT-ULTRAPAK-445-16-WAVE-SOLDER-MACH_W0QQitemZ220111865148QQihZ012QQcategoryZ58293QQssPageNameZWDVWQQrdZ1QQcmdZViewItem
Electronics Forum | Tue Jan 10 11:34:11 EST 2017 | charliedci
Have you contacted Speedline? They took over the Electrovert products and have provided us with parts and support on our 25 year old Econopak +.
Electronics Forum | Mon May 04 07:34:47 EDT 1998 | Scott Davies
Are there any vendors who sell aftermarket or used parts? I need the following: Finger cleaner pot for Electrovert Ultrapak 445 wavesolder machine. 856 flux ate right through it and Electrovert wants 2K for a new one. That's a lot for a 10" box! Ro
Electronics Forum | Wed Jul 16 06:38:17 EDT 2003 | Wave
We have acquired an UltraPak 600C wave machine and are investigating the possibility of installing a centre support wire conveyor to eliminate the use of pallets. What is involved in this project and how feasible is it? The boards have bottom side SM
Electronics Forum | Mon May 04 13:05:27 EDT 1998 | SMT-ASSY
Call Adtool at 514-482-2548 ask for Kevin perhaps he can help you. | Are there any vendors who sell aftermarket or used | parts? I need the following: | Finger cleaner pot for Electrovert Ultrapak 445 wavesolder | machine. 856 flux ate right throug
Electronics Forum | Thu Jan 29 12:47:53 EST 1998 | Henry Lee
I have an Electrovert Ultrapak 445 Wavesolder machine with 3 IR preheat zones and a single wave with omega wave. I want to run a DOE (Taguchi) to determine the optimum settings for soldering both single-sided and double-sided boards. Can anyone po
Electronics Forum | Fri Jan 24 09:26:29 EST 2003 | pjc
I sent you a couple of charts to assist with your troubleshooting. One is the Electrovert Wave Solder Troubleshooting chart and the other is Sandia Labs/Electrovert Optimum Solder Contact Time. Electrovert has a 6 deg. conveyor angle standard on the
Electronics Forum | Thu Feb 13 08:28:47 EST 2003 | pjc
Call 1-800-737-8110 for tech support. They can give you the N2 supply specs for the 650C. You should consider the cost to convert the Contour to a standard Lambda vs. the cost to bring in N2 and the consumable costs. Tech Support can give you the ret
