Electronics Forum | Thu Sep 10 15:01:28 EDT 2009 | mefloump
I currently spray DOW 2620 with my PVA650 without any problems. I do not thin it but I do have a distance between the coating machine and IR oven to provide a flash off period. I notice bubbles only when the flash off time is too short and the coatin
Electronics Forum | Tue Aug 14 16:18:48 EDT 2018 | dontfeedphils
A couple of things to try as I just went through this myself. Checkout this link for pointers on plasma cleaning... http://www.nordson.com/~/media/Files/Nordson/march/Papers/The-Effects-of-Plasma-Treatment-Prior-to-Conformal-Coating-NordsonMARCH.p
Electronics Forum | Fri Feb 18 08:08:55 EST 2011 | floydf
I have found that depressurizing the tanks when the machine is not in use reduces bubbles.
Electronics Forum | Tue Feb 08 14:23:47 EST 2011 | dennisfo
Conformal coat bubbles using 1B73 and SC-205 nozzle I've read most of the posts on this subject. I'm using the SC-205 (airless) fan nozzle and 400 needle to apply 1B73 mixed with xylene thinner. I have micro bubbles which come directly out of the noz
Electronics Forum | Mon Apr 01 20:33:30 EST 2002 | davef
Regarding your underfil ... * What material did you use as an underfil? * What machine and technique did you use to apply the underfil? * What type of component were you underfilling? * What was the end-use environment?
Electronics Forum | Wed Apr 19 11:50:05 EDT 2006 | amol_kane
Hi BJ, Everyone's favourite answer...it depends! If the volume if large, masking boots will save you both, time and money in the long run. Custom boots are relatively expensive to buy, but they pay themselves over time by savings on masking tape. ma
Electronics Forum | Wed Nov 30 15:15:34 EST 2016 | warwolf
Any lead free will eat a leaded designed wave soldering machine. But SN100c will eat it the slowest, our soldering tips used to only last 3 months with SAC305 when we changed to SN100c solder wire we are having around 9 months tip life. Our wave sol
Electronics Forum | Fri Jan 16 06:53:33 EST 2009 | stevewilde
I am using Humiseal 1B31 conformal coating and xylene mix on a PVA coating machine. Bubbles are appearing between the pins of LCCs mainly and bubbling is worse when put through the IR oven. Does anyone have any suggestions or tips to elliminate this
Electronics Forum | Fri Jan 16 10:54:21 EST 2009 | realchunks
Hi Steve, Make sure your spray head is all the way down. If so, try slowing your rate of speed over the part. Which head are you using to coat this part?
Electronics Forum | Mon Jan 19 09:10:17 EST 2009 | stevewilde
Thank you for all of the advice. I am using the extended spray for these cards. Humiseal have recommended using their own thinners 600 instead, so will run some trials with this and also the humiseal pre-mixed material (at the moment we mix our ow