Electronics Forum | Sat May 01 09:18:08 EDT 1999 | Bob Willis
| How's the "Great Gas-out" going for ya'll? | | Myself, I'm doing real good! Haven't farted all day...(GRIN) | | Anyways, a thread got started down below about this so-called "Lead Free" stuff, and I just wanna' put my two cents in about the whole
Electronics Forum | Tue May 04 14:37:44 EDT 1999 | JohnW
| Hi Ya' John! | | Here's my comeback to the points you've raised...you knew I would have a comeback, didn't ya'? | | |Steve, | | | | I see your point, and yes there are alot bigger fish to fry in |the removal or control of lead in the environment
Electronics Forum | Mon May 03 18:11:32 EDT 1999 | Steve Gregory
Hi Ya' John! Here's my comeback to the points you've raised...you knew I would have a comeback, didn't ya'? |Steve, | | I see your point, and yes there are alot bigger fish to fry in |the removal or control of lead in the environment. However even
Electronics Forum | Mon May 03 18:11:10 EDT 1999 | Steve Gregory
Hi Ya' John! Here's my comeback to the points you've raised...you knew I would have a comeback, didn't ya'? |Steve, | | I see your point, and yes there are alot bigger fish to fry in |the removal or control of lead in the environment. However even
Electronics Forum | Tue Apr 23 15:36:27 EDT 2019 | davef
Josh, are you setting someone up with these questions? Answers to your questions related to the subject line follow: Q1. Does the Epoxy Solder Mask Layer of a PCB protect against moisture absorption? Is this a primary function of the solder mask?
Electronics Forum | Thu Apr 14 05:23:10 EDT 2005 | dj_jago
What is the pitch of the device and what type of flux are you using? You may eridicate the fault by using a more active flux. I assume you are flowsoldering the device as opposed to paste in hole. Do you have an air knife? If so, you could tr
Electronics Forum | Wed May 06 08:15:39 EDT 2009 | xinxi
Hi all, I understand that this forum is more to surface mount discussion. But I am eager in sorting out the spray fluxer problem. Please provide me with any ideas that you think might cause it. I have a problem in starting up/initialising the wave
Electronics Forum | Fri Apr 13 10:13:30 EDT 2007 | Bob R.
We had a crisis with one BGA causing huge yield losses due to this defect. Nothing we could do with the profile got rid of it. Changing paste didn't get rid of it. It was the BGA warping in reflow, caused the corners to lift up when the solder was
Electronics Forum | Wed Feb 22 21:27:04 EST 2006 | gcolbert
Our solder paste machine has a squeegee problem. After passing over a board, the squeegees don't go all the way back up to their origin state. Then we are getting a timeout error and have to return the machine back to its origin (manually), and pass
Electronics Forum | Wed Apr 13 21:04:39 EDT 2005 | pdeuel
We have a controlled pressure facility. When the pressure is set at 0.2 lbs above outside our security doors that open outward do not close by themselvs causing alarms. Our facility remains dusty under and on equipment because of conditions listed on