Electronics Forum | Wed Dec 02 10:00:17 EST 2020 | spoiltforchoice
That STOP error code does google. It would suggest an incomplete or corrupted windows installation. if safe mode doesn't work its very unlikely normal mode is. Sadly fixing XP issues is much harder than it is these days with Win10 which has repair fu
Electronics Forum | Mon Mar 24 20:30:01 EDT 2014 | davef
The "correct" answer is: Use the tests and methods that you used to qualify your solder paste in the first place. That sounds good but might not be all that practical for practicing assembly-types. Here's something that's not as good, but will give
Electronics Forum | Thu Jul 03 19:27:54 EDT 2008 | proy
5 Zone HVA70 Oven Board 6 layer, 10" x 13" lots of space, most critical is 100 pin QFP AIM Water Soluble 487 Tin Lead paste on SN100C HASL boards This board is giving me disproportionate grief! I am running 23 in / min which gives me about 3.1 mi
Electronics Forum | Wed Dec 23 12:24:37 EST 2020 | ilavu
1. Palm down the GSM and open the safety cover to check input voltage +12VDC (at KDC2 3PL pins 2 to 3) and output voltage +5VDC (at KDC2 2PL pin 4 to 3) at the DC/DC converter. The DC/DC converter is located inside the control panel assembly ("Nose c
Electronics Forum | Tue Jul 26 09:48:44 EDT 2016 | leeg
Have you taught the tray position in correctly, I dont know that particular machine but you normally teach in 3 positions. When you have done this have you re-optimised?
Electronics Forum | Mon Jul 25 17:27:45 EDT 2016 | victoriajon
Up and running smoothly this morning, but got the attached error when switching from a reel feeder to a tray of the same part. We are getting this error message during setup - any suggestions are welcome. I am available to answer any questions that
Electronics Forum | Thu Aug 04 15:07:30 EDT 2016 | sumote
I have seen a similar error on a Quad 4C machine. When setting up the parameters on a tray part there are several points of data you have to input. You have to teach where the center of the 1st part (and you have to know which corner your machine con
Electronics Forum | Mon Feb 24 12:41:18 EST 2014 | mi
Depending on what X-Y centroid / CAD data you need, there are different SW I've used to do the job. If you need PCB gerber "artwork" (rounds, rectangles, lines, squares,...geometric figures), you can use GraphicCode GC-Place & such - load the gerber
Electronics Forum | Sun Feb 16 11:14:07 EST 2014 | unisoft
As mentioned the ProntoGERBER-CONNECTION software from Unisoft ( http://www.unisoft-cim.com/gerber_connection.htm) does the Gerber to intelligent shapes (ref des, x/y center, rotation, p/n, etc.) function for over 25 years. If you wish I'm availab
Electronics Forum | Wed Jan 22 10:35:38 EST 2014 | unisoft
_a class=roll > href="http://www.graphicode.com/GC-PowerPlace" > target="_blank"_http://www.graphicode.com/GC-Power > Place _/a_this does, I had a dabble and while it > does seem quite capable the learning curve is > quite steep and I'd wager th