Electronics Forum | Mon Apr 11 13:11:30 EDT 2016 | gbkellyk
Hi, I hope someone is able help me I have just purchased a used ASYS LSB03 bare board loader and when I have switched the unit on the display reads MODUL 02 OFF also the control panel is frozen and does not respond to any of the buttons when pressed.
Electronics Forum | Tue May 03 10:40:03 EDT 2016 | ttheis
Hi Swag- thanks for the reply. I did check the height definition of the component first. Its defined under the "other" category which I think is OK. Interesting point on the program being jacked- I did manually move those parts to the end of the rout
Electronics Forum | Thu May 12 01:20:48 EDT 2016 | darby
Check your interface boards and connections. Should be in your manual under "control rack/ board connection/ " then they have the various I/F boards. I don't know the initialisation sequence, but a PC whiz or Samsung should be able to tell you the or
Electronics Forum | Thu Jun 02 09:33:50 EDT 2016 | emeto
Hi, if I were you, I would probably go for testing and rework equipment. Adding manufacturing to your business, will most probably exceed your preliminary expectations. Manufacturing is much more complicated than you probably think. I have used manu
Electronics Forum | Wed Oct 12 02:44:38 EDT 2016 | bukas
hello, I have a problem with CP45FV Neo swing mirror. The mirror it self works fine, manually controlled it moves to correct position and back. While working it also moves properly but when machine is about to check for nozzle existence at the end of
Electronics Forum | Tue Mar 07 09:35:55 EST 2017 | buckcho
hello, I have a problem with CP45FV Neo swing > mirror. The mirror it self works fine, manually > controlled it moves to correct position and back. > While working it also moves properly but when > machine is about to check for nozzle existence a
Electronics Forum | Thu Oct 27 14:56:29 EDT 2016 | zippi
Communication parameters is correctly. DB25(Male) > to DB9(Female) wiring as is manual, lenght 1m, > shielded. When i try read mcf CSMUTB program > stoped with error "CSM not respond" or "Cant > established communication", CSM84 display 125 > Co
Electronics Forum | Wed Nov 09 08:56:22 EST 2016 | sumote
The screens go in with some paste left on 'em, (operators can only remove so much manually) > That is BS. We clean our screens by hand ONLY and I am able to remove all of the solder using a 1" putty knife and Micro Care Alcohol-Enhanced Flux Rem
Electronics Forum | Wed Nov 09 10:30:26 EST 2016 | jbreit
You're right. It is BS. I should have said "the operators are only WILLING to remove so much paste manually." When I brought up my concerns about leftover paste with the powers that be, I was told in no ambiguous terms that the operators will no
Electronics Forum | Fri Jan 13 02:54:25 EST 2017 | roblackey
When the YV100 starts up if you press a key > during its startup you can get it to ascreen > where it asks for passwords.. > > How would you > get the passwords from this Hi, if you haven't changed them then I think it's "specialist" on VIOS.