Electronics Forum | Mon Jan 16 13:37:56 EST 2012 | leemeyer
When looking at the feeder base the right side wires should be white, black, black, red from top to bottom. The left side should be red, black, black, white from top to bottom. You have IQ feeders hence the extra pins. The IQ feeders are only require
Electronics Forum | Wed Jan 18 06:22:23 EST 2012 | ngineer
I rang out the bases, the connectors are common (i.e from top to bottom, 1-1, 2-2, 3-3,4-4). I also measured voltage on the connectors. Front and back don't have any voltage, and the lights don't come on when I press the buttons. Left and Right ar
Electronics Forum | Thu Jan 19 15:57:29 EST 2012 | ngineer
Yup, that sounds right. I did try one with red on top on one side and white on top on the other side. Oops, blew a capacitor out of the back of the base. If anyone else Has these, here's how it goes to make them work: Top pin on both sides = +12V
Electronics Forum | Wed Dec 02 05:26:54 EST 2015 | udokorsmit
If you are interested in LEAN type of software where you have realtime view on your bottlenecks so that your operators are actually focussed on more performance, than our LineSight system will provide this info (and more). This is a completely new sy
Electronics Forum | Thu Aug 30 21:49:59 EDT 2012 | davef
Logic Circuits Based on Magnetic Semiconductors One problem with increasingly dense circuits is heat dissipation. A solution was recently unveiled by Northwestern University researchers using an entirely new logic circuit family based on magnetic se
Electronics Forum | Fri Mar 22 12:11:56 EDT 2013 | emeto
Hi, I will focus on the flux one more time. Try different amount(usually more flux should give you better result). Also depends what kind of flux you are using? Water based or alchohol based? Try with another type that you are using. Check the spee
Electronics Forum | Mon Oct 28 08:27:53 EDT 2013 | emeto
There are many profilers(physical devices) on the market. Most of them have software that makes predictions based on information about the paste, oven model...., but I wouldn't trust the predictor as on your boards you will have different parameters
Electronics Forum | Tue Feb 21 03:20:57 EST 2017 | pcbcart
We're a custom PCB manufacturing services provider based in China and we have made many high quality circuit boards for high end products. Based on your project requirements and our years' experience, we are positive that ENIG is totally sufficient.
Electronics Forum | Thu Mar 23 02:10:59 EDT 2017 | alexeis
Hi, Based on our experience, you can collect X-Ray analysis of solder joints and calculate values of SPC (such as PP/PPK and GR&R). Now, you can find, based on this calculated values, if your production is good or not. Also, this helps you to detect
Electronics Forum | Tue Jul 25 12:39:41 EDT 2017 | emeto
Hello John, the answer of your question is more organizational than technical. Most CEM use their own part number system(you will need to purchase software for that), and that is exactly what you want to do.You can have 5 different resistors 10kOhm