Electronics Forum | Fri Aug 26 01:46:04 EDT 2022 | angela t
The drive and power supply were checked and were fine, but later I found that there was a problem with the J22 cable, which would alarm if I touched it. I suspected that the cable was damaged and planned to buy a replacement cable to try.
Electronics Forum | Thu Oct 13 15:38:18 EDT 2022 | proceng1
Do you have the ability to add copper thieving or otherwise balance the design? We had a customer making LED boards with a terible inbalance. Some of the boards would "smile" so badly in the oven that the leading edge touched the top. They switche
Electronics Forum | Sun Mar 05 15:11:32 EST 2023 | dontfeedphils
Hope you can get in touch with the right people. I used to deal with the people in the US and they were always helpful and quick to reply.
Electronics Forum | Mon Apr 10 04:22:41 EDT 2023 | dilogic
what is the size of that diode? We had some issues where part was sucked out of tape before nozzle actually touched it and flipped in the air.
Electronics Forum | Fri Jul 23 23:47:03 EDT 1999 | Scott McKee
| | | There is a practise within the industry of an Inspector inspecting a board, and that same Inspector performing touch-up. My opinion is that the Inspection and Touch-up operations should be separate functions whereby the Inspector is not perform
Electronics Forum | Sat Jul 24 00:04:55 EDT 1999 | Scott McKee
| | | There is a practise within the industry of an Inspector inspecting a board, and that same Inspector performing touch-up. My opinion is that the Inspection and Touch-up operations should be separate functions whereby the Inspector is not perform
Electronics Forum | Fri Feb 25 16:06:51 EST 2000 | Dave F
Istv�n: Given a choice, I�d run second side PLCC44s at 90� to the wave. As far as thieves are concerned, I�d have two, mirror images of each other. Unlike most, these thieves are not connected to pads. They are out-side of the last pad on the sid
Electronics Forum | Thu Feb 10 09:08:21 EST 2000 | C.K.
We've got this hard-to-Wave-solder board where all of the SMD's are on a ground plane - in fact the entire bottom-side is a ground plane. Our designers have incorporated thermal relief on some of the pads, but for reasons unknown to us, they don't h
Electronics Forum | Fri May 12 09:24:45 EDT 2000 | Ashok Dhawan
I need to install two SMD chips (0805) at one location. I refered to IPC-HDBK-001, fIG 6-24. When I solder the chips side by side, the ceramic side which is placed againgst solder pad- is already touching the solder. While I complete the solder joint
Electronics Forum | Fri Feb 25 16:06:51 EST 2000 | Dave F
Istv�n: Given a choice, I�d run second side PLCC44s at 90� to the wave. As far as thieves are concerned, I�d have two, mirror images of each other. Unlike most, these thieves are not connected to pads. They are out-side of the last pad on the sid