Electronics Forum | Tue Oct 03 16:38:26 EDT 2006 | cuculi54986@yahoo.com
You can get prototype stencils for $140 from Stencils Unlimited. I've never used their services but I have considered it. The stencils are frameless and even come with a hand squeegee for you. http://www.stencilsunlimited.com/prototype_stencils.ph
Electronics Forum | Tue Oct 03 18:01:24 EDT 2006 | stepheniii
If you do find one, you will want to cut some kind of "handle" with it. You might want to practice cutting a different pattern first, if you only find one of the pattern you need.
Electronics Forum | Thu Oct 05 10:55:21 EDT 2006 | OSW
I used to be pretty active on the selective memory front. Now I'm lucky to remember stuff I want to, never mind stuff I'd like to forget (although typically my spouse won't allow it).
Electronics Forum | Wed Oct 04 03:44:23 EDT 2006 | slaine
you should be able to work out the resistance of the heater element from the power rating (watts), and the Voltage its working at. then measure the resistance of the element and see if your anywhere near.
Electronics Forum | Wed Oct 04 03:48:14 EDT 2006 | slaine
Ps the above answer was to test if the element is failing, if you think the element is not working due to the current supply being limited you can carry out the same calculations but work out the current required then put an ammeter in series with th
Electronics Forum | Wed Oct 04 16:30:12 EDT 2006 | russ
I hope you are not trying to melt the Ceramic BGA columns. these are not meant to melt. I would run a lead process at peak temp of 225 -230C with lead paste. The board warpage may be of design issue or Manufacture issue. Russ
Electronics Forum | Wed Oct 04 18:21:04 EDT 2006 | stepheniii
We have a board we run screwed to a fixture. There is no warping that way. If you go for reheating the BGA's make sure there is no time for the BGA's to absorb moisture.
Electronics Forum | Wed Oct 04 16:18:06 EDT 2006 | cw
My Peak ~ 228-230C (customer wants to see this temperature). solder ball size - 20mil diameter Please advise ASAP. Thanks a lot!!!
Electronics Forum | Wed Oct 04 16:19:54 EDT 2006 | russ
you may want to try a different MFGR of paste, this does help on many occasions. Russ
Electronics Forum | Wed Oct 04 16:47:25 EDT 2006 | russ
very minimal at very few locations. We do not Xray every board but sample them. I think you will find pretty good results here (not perfect) Russ
.gif)
