Electronics Forum | Wed Apr 03 09:12:11 EDT 2024 | hta1979
You have to enter the setup utility.Power off the machine,connect AT keyboard to the rear port, power on,press f1, load the bios setup defaults, enter the hdd parameters,in the first menu (Standard CMOS setup) (Cylinder,Head,Sector,Wprecomp) save the
Electronics Forum | Fri Apr 05 01:23:29 EDT 2024 | ddfreeze
thank you so much for the info, wished I would have known previously, however I found the motherboard manual online, and located the Dallas CMOS chip soldered to the board. Found a lot of youtube fixes online. Dremel tool and some soldering, added an
Electronics Forum | Fri Apr 05 01:52:57 EDT 2024 | ddfreeze
Samsung SM321 machine fails to initialize when booting software. I have swapped PCI and communication boards, all resulting the same, I replaced the CMOS battery on communications board, tested the voltage on the backplane, and reloaded the software
Electronics Forum | Mon Apr 08 18:16:20 EDT 2024 | mistrthou
We had a Mycronic tech in adjusting rings to get us within spec. He was saying the emitter/receiver board at the top and the tubes themselves can go bad. Between that and having weak latches, we're looking at a refurbished unit. But we're rocking a M
Electronics Forum | Mon Apr 29 12:35:13 EDT 2024 | radek
Fuse was ok but the resistor which feed optocoupler was burned out. After replacing resistor everything is working fine. Now I've got error: "Infeed disbaled" - but this is configuration error ? BTW I have one more question - can I use this machine
Electronics Forum | Thu May 09 11:29:06 EDT 2024 | oxygensmd
I have tested extra-eye only but there are many other machines for this task. The question is how you want to solve this problem, inline or off-line? I highly recommend that to you, to check YouTube. There are many training and example videos about
Electronics Forum | Thu Feb 17 14:10:37 EST 2000 | C.K.
I'd have to agree with JAX here. This forum is intended to be a "Technical Bulletin / Newsgroup" and nothing else. Truthfully, these posts of the "old-timers" announcing their departures is getting..well.....OLD. I hate to see the Old-timers leave
Electronics Forum | Wed Feb 09 16:09:06 EST 2000 | Doug
Does anyone have any ideas on setting up a parts library/database on an SMT line? We would like to identify a particular part by it's package style, instead of by the customer's part number, in order to reduce the amount of entries in the library.
Electronics Forum | Fri Feb 11 12:21:44 EST 2000 | Finepitch Services
Doug, What I've done in past was calling them as 1206T.5, 1206T1.0, SOIC16, RESNET16, SOIC16T5.0, ALCAP4, ALCAP5 etc. T means thickness but for the ALCAP case 4 means 4mm diameter. If you have the time and patience, having a board and attaching a s
Electronics Forum | Wed Dec 13 14:15:54 EST 2000 | Chris
I have a product where an IC is soldered using a stencil which puts down way too much paste. The result is massive bridging. Anyway, one of my coworkers claimed he could eliminate the bridging by baking the circuit board in an oven for 5 min at 90
