Electronics Forum | Thu May 31 10:21:16 EDT 2001 | davef
On "Flip Chip/uBGA Under-fill Visual Standards" � The third "Satisfactory" [The under-fill if by design should be visible � ], here the notation "if by design" is unclear. Does "according to product documentation" get to the point? The first "Acc
Electronics Forum | Thu Jun 28 08:14:11 EDT 2001 | Stefan Witte
I visit customers on a contract base to get the machines in a status, that an operator can take over. These customers are usually small shops, who can not effort an engineer to set up the machines. I am not afraid of my job, if it does not require a
Electronics Forum | Mon Jul 16 21:25:26 EDT 2001 | davef
Sure, use of U-shape apertures is another way to reduce the amount of paste that you apply. That and similar schemes mentioned in the article are not a function of the flux used. We have used U-shaped apertures for MELF and mini-MELF. They are sug
Electronics Forum | Wed Aug 01 09:36:17 EDT 2001 | Pete Barton
Jay, > > I agree with your assement and Chips on > the Quads. I once worked at a shop that had Quads > and DynaPerts(at the time) The perts were > slower(TIME) and required(EFFORT/PEOPLE) more > MAINTENANCE(more effort more people and more > re
Electronics Forum | Tue Sep 28 22:43:26 EDT 1999 | Dean
| I finaly get a vacation and decide to go to the forum and low and behold it's hot air verses a small ray of sun.I read every thread and still failed to see any real argument either way? I love rework as an assembler. I hate rework as a shop owner.
Electronics Forum | Tue Sep 07 20:46:55 EDT 1999 | Jeff Ferry
| | | My company is starting a prototype. The chips that will be used appear to be very sensitive. The vendor part number is Neta-40-2. | | | My question is what solder temp should be used for this part? | | | Any advice is appreciated. | | | THX. |
Electronics Forum | Thu Sep 02 16:52:31 EDT 1999 | Earl Moon
| | | Has anyone done or seen any studies done documenting what may be the affect of hardware such as screws in the parimeter vicinity of BGAs on a circuit board? | | | | | | What I'm really after is anything describing how close a screw/washer/nut
Electronics Forum | Thu Aug 26 04:35:54 EDT 1999 | Wolfgang Busko
| | | Does anyone have any information on stencil aperture/pad ratios for noclean solder paste. In the past I have experienced severe solder ball problems when using the same size apertures from aqueous products as I do with the No-clean products.
Electronics Forum | Sat Jul 24 10:20:15 EDT 1999 | Bob Willis
PCB Solder Finishes Survey Questions 1999 Results for the 1996-7 survey are located at www.smartgroup.org As a number of SMART people have requested an update on the solder finishes survey SMART Group have run in the past here is your opportunity t
Electronics Forum | Thu Jul 08 15:38:27 EDT 1999 | Earl Moon
| Thank you all for your replies. Thanks to your replies and backup from the IPC-SM-782A (section 3.6.3.2) and James Blankenhorn's "SMT Design Rules & Standards," the designer has agreed to provide adequate clearance between the via and the pad. |
