Electronics Forum | Tue Mar 04 11:47:58 EST 2003 | msivigny
Hello John, Your second statement is a little vague about the 16th card shutting down the line with the 2x240 QFPs misplaced... i'll try to interpret, assuming the cards are actual product, which I think they are, your 16th card failed because 2 out
Electronics Forum | Fri Jun 13 22:04:47 EDT 2003 | iman
I would say, if one guy buys used machine from a "dealer", the dealer ought to cover the registration fee up-front for the buyer as part of a complete package, UNLESS the buyer himself/herself asked for a discount that purposefully omitted the requi
Electronics Forum | Fri Oct 03 08:58:22 EDT 2003 | SMT Process
Folks, I use both UP1500 and AccuFlex. The basis for this machine was bought from SMTech several years ago as the SMTech 500. They sold off the last few SMTech machines with the MPM name on them (stupid move because they sucked), but then quickly r
Electronics Forum | Wed Dec 10 15:45:02 EST 2003 | Carl
If your operation is hi-mix low-volume, consider > taking a look at some of the bench-top units out > there. They are lower cost but can give similar > performance as higher cost in-line systems. Some > of the bench-tops cannot do solder fillet
Electronics Forum | Wed Jan 28 09:46:27 EST 2004 | stefwitt
I don�t know, what you are going to do with this type of request. Are you indeed making up your mind because a few readers give their hands up or down? All the machines listed above do a good job. However, consider that you will be married for a long
Electronics Forum | Wed Apr 21 12:21:57 EDT 2004 | davef
Please help us understand your situation better. * How do �Having Problems W/ Parts Moving At Reflow� and �When the boards come out of the oven the pads look very wet from flux� relate to one another? * Tell us about solder, flux, reflow profile, and
Electronics Forum | Tue Mar 28 07:28:25 EST 2006 | Rob C
I would have to disagree on this. My experience is that you should never justify capital expediture based on just the obvious up front costs alone. There is no mention of risk of recall, warranty costs, scrap costs,and so on. Which you may get from a
Electronics Forum | Thu Jun 24 14:34:13 EDT 2004 | tjensen
There are many factors that can lead to solder balls. Since you have just recently seen this start to occur, it is obvious something has changed in the product or your process. Since we don't have a lot of details about your process, I would sugges
Electronics Forum | Sat Nov 20 09:29:36 EST 2004 | JB
You are not giving the dimensions of the space to be used by your machines. So it's impossible to know what we are working with. But here is scenario for a very small floor space assuming that you can't have the equipment in a single line: I am ass
Electronics Forum | Tue Mar 15 18:42:57 EST 2005 | simmcircuits
Hi, Can anyone give me a bit of an advise or tip on how to reduce the flux residues on the board when it comes out of the wavesolder machine. The Vitronics Soltec 6622CC that we are using have been producing boards like this for years and people her
BAJA Bid was founded to form an auction organization with the primary objective of providing an outstanding experience for both our buyers and sellers.
Equipment Dealer / Broker / Auctions
13227 Royal George Avenue
Odessa, FL USA
Phone: 813-992-2437