Electronics Forum | Fri Mar 20 02:10:03 EDT 2020 | weglimir
Hi Printer is DEK265GS if I remember correctly. It is definitely not a programing problem, I have 15 different screens which I've checked and all are working fine. It is also not a problem with Y shift, as I've compensated it with CUSTOM SCREEN o
Electronics Forum | Wed May 06 18:15:03 EDT 2020 | travishemen
I thought i posted this last night. The easiest way I can think of to see what nozzle is being used is to put the machine in step mode and do one part at a time. Also the levelness of the table and Z0 could be suspect. On a CP643 this can get out
Electronics Forum | Wed Jun 03 19:19:37 EDT 2020 | kurtiss
Hello, I am having an issue with a Fuji CP4-3 where during the nozzle center the image displayed by both the wide and narrow view camera is a black square. We have checked the cable coming from the 4400 Card and all checks out. We have also pulled t
Electronics Forum | Sun Aug 16 18:38:19 EDT 2020 | jmelson
Well, I have now traced the ready button all the way into the DPRAM board, and all looks good going into a big flat pack chip, valid TTL logic levels when I press the button. But, the machine will not go ready. I have no errors in the system error
Electronics Forum | Fri Jan 15 14:32:12 EST 2021 | marcelorotofrance
Hey there We have a second hand (or third or fourth...) Contact 3Z-100 non functioning, received as is. I am in the process to asses its condition and try to get a diagnosis. After DOS boot, 3Z.EXE executes and in the screen it reads: "Initi
Electronics Forum | Thu Mar 18 19:53:29 EDT 2021 | lhd_qa
Hello everyone. I am new to the forum so I am sorry if this has been asked before. Does anyone have any suggestions for counting partial reels and cut tape? We are a distributor and for our ecommerce PDC we keep having quantity issues. Currently, we
Electronics Forum | Sun Apr 11 13:48:33 EDT 2021 | ngumado28898
Hi guys, I'm a newbie for SMT field. Currently, I'm facing a problem that there were many defects such as tombstone, missing, skewed, billboarding that happened with 1 type component (Resistor 0201) with a specific supplier X (we have many supplier b
Electronics Forum | Thu Jul 01 16:02:45 EDT 2021 | willkillum
Greetings. Make sure the calibration/homing chip is still with the machine and not lost, although you can buy a replacement from Juki for a not-so-nominal fee. Also, have the seller power it up and bring up the Laser image display/edge check. If ther
Electronics Forum | Thu Jan 13 15:17:27 EST 2022 | goseese
Thank you very much I will look for something moving, loose or getting pinched when the table moves. -- Update -- checked every single connector, all the purple cables/connectors too. Everything it tight and not getting hung up. Checked all the
Electronics Forum | Thu Jan 12 16:53:59 EST 2023 | SMTA-67037450
I need to benchmark or sanity check our incoming inspection process in relation to IPC Class 3 electronics. I am looking for a contact with someone who assembles/builds IPC Class PCBAs, that i can sanity check some stuff with. To start, our process