Electronics Forum | Wed Jan 26 08:36:06 EST 2005 | jdengler
Sasha, A standard RS-232 cable with the proper connectors would work. If you want you can make it. Normally the PC will have a DB-9 theses days so the wiring would be PC Machine DB-9 DB-25 2------2 3------3 5------7 Good
Electronics Forum | Fri Feb 11 01:36:22 EST 2005 | brown
OK I am counting someone knowing this. True or False, if my touch-up operators touch-up the smt solder joints too many times will this make the joint weaker? if yes why? and what happens to my intermetalic layer? I have insisted if it looks good don
Electronics Forum | Wed Feb 16 10:38:19 EST 2005 | pr
It's been a while but I believe we did this and it'll work (misspicks WILL go up though). I would make a quick test program and pick 50 or so parts from a feeder and place on a board with sticky tape. Placement won't really be the issue, just pick up
Electronics Forum | Tue Feb 22 09:01:50 EST 2005 | davef
It could be that you're starting with hyper corroded nickel, before you even begin work. With electroless nickel, everybody looks at the nickel, but the cause turns out to be the immersion gold is too aggressive [during fabrication]. Immersion gold
Electronics Forum | Fri Feb 25 15:08:30 EST 2005 | jdengler
John, We tape (usually high temp tape) flex to a fixture (usually 0.090" piece of bare FR4). We make an outline on the fixture to get a rough location then use fiducials on the flex for alignment. Print, place, reflow, cool, remove flex. When the
Electronics Forum | Mon Mar 07 08:53:59 EST 2005 | Marc
some thoughts come to mind..... usually an air pocket as the solder heats up, or the surface is still solid and liquid under, pressure builds and then... check your heaters, make sure one (or more) is not bad, may be getting uneven heating. cover y
Electronics Forum | Thu Mar 10 15:43:06 EST 2005 | steve
Thank you both for your assistance. I knew that I could count on you folks. The customer has purchased No-Clean flux and is using it as we speak. Hows that for customer service.... All in a days work... Thanks again You make me look good!!! Steve
Electronics Forum | Fri Mar 11 11:19:02 EST 2005 | Steve C.
I would change the Quad Align cable. If you have a spare head board swap that out as well. Make sure your Quad Align lenses are clean. If the camera is smudged then you can have some problems aligning parts as well. Let us know what you find. Cheers.
Electronics Forum | Mon Mar 14 08:35:27 EST 2005 | ???
no...its losing its position and it homes ok so the sensor is not the problem.....there is a mod code that sets the illumination level for the quad align....make sure that is at 200 or higher. You may want to change the qa card if you have another on
Electronics Forum | Mon Mar 21 21:28:41 EST 2005 | pmd
I agree with dave. Two things prevent oders from drains. The "P" trap and the celing or roof vent. If the system is sealed from the pump on then it should run thru a "P" trap this prevents vapors from comeing back thru the pipe. To make sure suction