Electronics Forum | Thu May 01 06:42:25 EDT 2014 | cbeneat
I use Simple Green, works pretty well, although I use the concentrate and don't dilute it as is recommended, so it's pretty strong. I am going to try the sugar water though. I'm intrigued.
Electronics Forum | Tue Apr 15 16:07:18 EDT 2014 | rway
Rather than using an over-lay of both pads, I would just stay with a rectangle pad shape, a little wider to accommodate both footprints. Keep it simple.
Electronics Forum | Tue May 06 16:18:37 EDT 2014 | emeto
Robgd3, if it works that way I will invite you to lunch too....:) What a story....this one is really good.
Electronics Forum | Fri May 02 19:02:21 EDT 2014 | mac5
You will have to open each parts Shape Data, Click on the Shape Process tab, Click on the Process tab, towards the bottom of the page under Error change the Dump Position to Box. This should work. Good luck.
Electronics Forum | Tue May 20 20:18:23 EDT 2014 | g2garyg2
Yes we solder them for a variety of customers. Your inquiry is not specific to what you are seeking info on.
Electronics Forum | Wed May 21 02:15:26 EDT 2014 | aflex
Not very sure of. But can help you in getting the right actuators. Contact this company http://www.venturemfgco.com/. They got a good name in actuator manufacturing. For any PCB requirement contact us for the best deal.
Electronics Forum | Wed May 21 03:59:05 EDT 2014 | aj
Hi, If you can advise any assembly issues or concerns regarding this type of part and also... 1 - Can you confirm that they come in tape & reel format? 2 - Is it a requirement to have a glue dot in the centre of the pcb pads? Thanks, AJ...
Electronics Forum | Tue Jun 10 21:15:01 EDT 2014 | comatose
We had a similar problem once, it was due to insufficient v-score depth. While waiting for remade PCBs we would run an exacto knife along the score lines prior to depanel to cut a little deeper. Not ideal for sure, and not fast, but it worked.
Electronics Forum | Fri Jul 04 06:49:41 EDT 2014 | padawanlinuxero
Hi We had the same problem but it turns out the problem is with the supplier we use a water base flux too, supplier change the solder mask and it work. cheers!
Electronics Forum | Tue Jun 10 11:51:15 EDT 2014 | rway
Your target ppm in on the Juki machine a take it. So it's rejecting these parts due to the inversion? Any way to disable this. A right-side down resistor is not ideal, but it will certainly work electrically. Reese