Electronics Forum | Fri Dec 14 11:27:57 EST 2007 | floydf
I have had luck with New England Belting: http://www.newenglandbelting.com/ Good Luck
Electronics Forum | Sun Dec 09 17:41:34 EST 2007 | airforcess927
The only thing JVC has told me was to take it the whole way to New Jersey to the closest service center.
Electronics Forum | Mon Dec 10 17:43:28 EST 2007 | hussman
Looking for a thru hole part that you can solder a wire or leaded part to. I remember using them in the past - but the name escapes me. It had a forked end that the lead would fit into. Any help appreciated.
Electronics Forum | Mon Dec 10 19:34:46 EST 2007 | davef
Hussman Select one from each of the two columns: Column 1: Bifurcated, spade Column 2: Lug, post, terminal Look at A-610D, 6.7.2 to confirm the name.
Electronics Forum | Thu Dec 13 10:35:36 EST 2007 | slthomas
What a preposterous notion. I question your desire to retain your current employment status. This clearly mandates a meeting! Harrrumph!
Electronics Forum | Thu Dec 13 11:55:41 EST 2007 | realchunks
You're right. I do care too much. I should work on that. I guess it is better to just point out a problem ina meeting and waste resourses, rather than resolve it.
Electronics Forum | Wed Dec 12 21:43:16 EST 2007 | davef
There is no specification for solder paste height, just as there is no specification for paste volume. Focus on producing a fillet that meets J-STD-001. You make the choices that produce the end result.
Electronics Forum | Thu Dec 13 07:10:38 EST 2007 | realchunks
There may not be an exit cell. Some go by timing. But double check your set-up. Make sure you didn't flag for an exit cell - not sure this is your problem. It also could be your timing. You can simply turn off the the dropped board warning optio
Electronics Forum | Thu Dec 13 17:21:04 EST 2007 | marcelll
How can you turn off the alarm ? I checked in the menu but the only topic I've seen is asking for a "factory password" witch I dont have. I have the administrator password.
Electronics Forum | Mon Dec 17 12:12:18 EST 2007 | Claude_Couture
in very rare occasion I had problems with BTU ovens, I contacted BTU directly and they were always helpful.