Electronics Forum | Fri Jul 10 18:47:27 EDT 2015 | alphatronique
make sure noting stock in the X ,and motor brake work usually machine supply 24V to motor brake wire for release brake then move until hit the end stopper for init motor if brake keep on that will the error message i got it often on the Z cause
Electronics Forum | Thu Dec 17 06:22:37 EST 2015 | sarason
AN inductor probably 22uH 5A. Check a TDK catalogue http://en.tdk.eu/inductors Another approach is identify the power control IC next to it and look up the App note associated with it, 9 times out of 10 it will be the same as recommended. Are you s
Electronics Forum | Tue Feb 16 13:58:02 EST 2016 | tsvetan
this document http://www.latticesemi.com/view_document?document_id=671 may be good start point but note that how to escape from the BGA is not big deal, how to route your filtering capcitors, grounding, impedance control lof you high speed signals ar
Electronics Forum | Thu Nov 03 14:33:40 EDT 2016 | csm
Dear JummyB We noted that when the machine is initializing, and when all check step pass, we just push ready button and the main relay or contactor must be activated but is not, it looks like one Card in front of the machine where all the drivers ar
Electronics Forum | Sat Dec 03 05:59:42 EST 2016 | sophyluo1985
Hello Peter, I'm sorry for that i can't solve the problem of your machine. But we can supply spare parts for Siemens/Siplace X feeders. Please kindly let us know if you need. Thanks a lot. Sophy Please note our websit http://feedersupplier.com/Catego
Electronics Forum | Thu Jan 12 13:54:47 EST 2017 | swiese242
We have a Seho PowerWave that is dual wave and we are having trouble with results only on one production board. These boards are from overseas to side note. I have played with speed, flux, and height with the same results. I am now looking into diffe
Electronics Forum | Thu Jan 19 11:10:13 EST 2017 | rgduval
I'd start by checking the manufacturers documentation, and seeing if they have any application notes regarding reflow recommendations for the part. But, in general, make sure to bake the parts prior to assembly, they are notoriously moisture-sensiti
Electronics Forum | Thu Aug 10 07:29:43 EDT 2017 | stivais
How do you evaluate the soldering quality for those QFNs? X-Ray or AOI? For some QFNs (and other bottom termination components) it's not supposed to have solder fillets on toes. It's also noted in IPC-A-610 (Rev.F 8.3.13). Take a look at your QFN ch
Electronics Forum | Fri Oct 27 03:02:54 EDT 2017 | praveenmuthusamy
Dear All, what might be the reasons for servo alarm on W axis in YXI(X RAY INSPECTION MACHINE)?? MAKER: YAMAHA TYPE: KLC-0000 NOTE:MACHINE CANNOT BE RESET UNLESS POWER SHUTDOWN. MACHINE RETURNS TO NORMAL STATE ONCE POWER SHUTDOWN AND RESATARTED! R
Electronics Forum | Fri Nov 10 22:31:27 EST 2017 | myke03o
Hi, we are experiencing insufficient solder and bridging solder. Any recommendation on the inner pad (LGA) and stencil thickness. Any suggestion will be very helpful. link: http://www.latticesemi.com/~/media/LatticeSemi/Documents/ApplicationNotes/
.gif)
