Electronics Forum | Thu May 28 09:39:19 EDT 2015 | emeto
Good luck Alexandru. I went through this years ago and it is a lot of fun. For the next 5-6 years you will learn a lot about P&P systems, as you will get your feedback from your customers(trust me it is going to be a lot and you will have to modify
Electronics Forum | Thu May 14 12:29:39 EDT 2015 | christinapaz
Hi All, On occasion we see components that have gone through pick and place and are slightly misaligned. Currently, operators manually adjust these misaligned components to prevent reflow failures. However, I am wondering if this readjustment may be
Electronics Forum | Fri Jun 05 03:59:17 EDT 2015 | buckcho
Hello, I also have a sample, but my lines are very busy. As soon as I test it I will post some results here. I am trying currently to see how much money is this paste going to save to the production, just from special deliveries (special packaging fo
Electronics Forum | Fri Jun 26 04:26:11 EDT 2015 | grahamcooper22
In the EU these companies have great equipment and experience with laser soldering systems...you have to make sure you use the correct wire / paste....Almit is the best. http://www.wolf-produktionssysteme.de/en/ http://www.mtaautomation.com/ Maybe c
Electronics Forum | Wed Aug 19 03:24:49 EDT 2015 | pcbman
I ordered few times of prototyping gold plating > pcb from China. How to i differentiate they are > ENIG or Flash gold? Hi,Friend , this is very easy to distinguish the ENIG and gold plating pcb, you can stratch the solder mask off and see the co
Electronics Forum | Fri Aug 14 10:02:23 EDT 2015 | swiese242
Yes your CP8 should place these flawlessly. I would calibrate the machine and check your nozzles. We have some CP7's and they rock. We use a .4 nozzle for the 0201's with no problem. Always check your program, feeder, nozzles, and nozzle check before
Electronics Forum | Thu Aug 27 07:56:24 EDT 2015 | grimus
Hello Do You have any experience with Device/Equipment that could make video recording inside inline reflow oven located after soldering PCB? I am facing with random problem with dropped parts inside reflow oven and I would like to see what is going
Electronics Forum | Tue Sep 22 14:23:42 EDT 2015 | travishemen
We had 4 of these machines several years ago. If I remember right the drive that aligns the board to the stencil was stepper motors with no encoder feedback. We would see the same issue if our leadscrews and linear rails were not clean and properly
Electronics Forum | Tue Oct 27 11:30:57 EDT 2015 | atekcare
Didn't see if anyone responded to your question offline, but if you are still evaluating laser depanelers, we would like to help? Here are just a few key factors to consider. (1) what material are you cutting? (2) what is the material thickness (3)
Electronics Forum | Mon Oct 12 19:12:13 EDT 2015 | cusackmusic
Looking are "new" stencil printers. Have heard a lot of people like the Ekra. I see there are X5s, X4s, and X1s available all over the place. I can't figure out what the differences are. They seem similar, and are similar vintage. Any insight?