Electronics Forum | Tue Mar 12 11:49:50 EDT 2024 | jergod
Thank you for recommendation. SAKI is not on my list because i dont have support/service for it on our country, but maybe i still should take it on list and give a little time for it to get demo for it.
Electronics Forum | Thu Mar 14 17:55:20 EDT 2024 | alexv
It's been a bit too long. But, I remember having the P-tools programs and components definitions saved some time. But, I'm sure things have changed, since then.
Electronics Forum | Wed Mar 20 15:01:37 EDT 2024 | linux
Reboot usually does the trick, Reason for these fault, (1) Nozzle holder, the grippers are holding the nozzle too tight, stretch the spring slightly, (2) shaft is sticking, removed the head lubricate the shaft.(3) Nest not opening and closed within t
Electronics Forum | Wed Mar 20 15:40:01 EDT 2024 | jergod
Thanks, When you have used koh young last time? I've talked with koh young engineers and they have been saying that they have updated softwares and there shouldnt be that much problems anymore.
Electronics Forum | Thu Apr 04 18:38:08 EDT 2024 | ronh22
I have the rear panel off and I can see the Drive but there is very little clearance looking down or working. Where are the fuses located? We also had the breaker pop a few times on out main breaker before this happened.
Electronics Forum | Tue Apr 23 09:22:02 EDT 2024 | wippsen
of course it has an impact on line capacity. x-out boards have a shorter cycle time, but you have to push more panels through the line to reach the order quantity
Electronics Forum | Wed Dec 05 17:30:02 EST 2001 | davef
How do you know that "approx 450�C" is "too high"? As a side, the temperature on the temperature sensor is: * Inaccurate. * Not the temperature at the solder. Listen, operators are smart people. They have figured-out that they can solder faster wi
Electronics Forum | Sat Aug 10 10:57:23 EDT 2002 | finepitch
> A/cph, then you need a second chip shooter. Then each chip shooter will place B/2 parts and possibly catch up with the pick&place machine. If the line has 2 chipshooters and a pick&place, it will be pretty hard to use the one unused chipshooter fo
Electronics Forum | Fri Mar 07 08:47:45 EST 2003 | msivigny
Hello Peter, In reflow, running a profile and collecting thermal data does not necessarily make it easy to calculate and determine machine capability. On the contrary to your desires of simplifying the process, determining machine capability on an ov
Electronics Forum | Tue Sep 26 20:14:29 EDT 2000 | Dave F
I agree with Wolfgang that a check list, like he proposes, is very useful in evaluating your ability to assemble products. No sense designing a 16 inch board if the throat of your wave is 15 inches. Taking a different tact � what if you define your