Electronics Forum | Fri Apr 04 18:08:26 EDT 2008 | comatose
We are a small OEM that runs a high mix/low volume environment. Typical runs are a couple or five hundred boards, one or two products per day. Currently, we are using a Quad DeHart SLC-20 semi-automatic stencil printer. (alignment is manual, printing
Electronics Forum | Sun May 04 19:18:42 EDT 2008 | dman97
Hi all, I recently acquired a year 2000 dek 265 horizon. It has a manual screen loader with that stupid hand crank adjustable stopper. Can anyone tell me how I am supposed to measure the stencil image dimensions for a front justified stencil? Now on
Electronics Forum | Sat May 17 18:53:56 EDT 2008 | mika
I would suggest You to Contact UIC S/W development department in Germany and ask for Peter Raab. European Headquarters � Neu-Isenburg, Germany Phone: +49 (0)6102-8822-0 Normally I guess that one asked such a question here, just because of not to be
Electronics Forum | Mon May 19 10:35:58 EDT 2008 | samir
I agree with RealChunks. The application of any of these "wave solder process control tools" is dependant on how the shop is run. At some shops, PM is inconsistent and slacked off on. At other shops, there is no technical expertise at the operator
Electronics Forum | Fri Jun 20 09:20:04 EDT 2008 | ampearl
I need a technical specialist to turn-on, trouble-shoot, modify, repair, and test the power supply prototypes at the printed circuit assembly and instrument levels. This person would be involved in setting up both manual and automated tests, making m
Electronics Forum | Wed Sep 17 05:18:55 EDT 2008 | ralphspm
Our Fuji IP2 has a problem reading fiducial marks.It finds the mark(is shown on console display) but after time gives out the error statement "image display time over".It gives out an error status code of "FFFC" on the console display.Cannot find any
Electronics Forum | Thu Oct 02 17:55:16 EDT 2008 | davef
~le sigh~ makes a good point about forcing bent leads into the solder, letting the solder cool, and releasing the force on the lead. On the other hand, reforming leads of components prior to assembly is dangerous, also, because the "bending of a lead
Electronics Forum | Wed Oct 15 17:20:57 EDT 2008 | mbrunton
2, I have to scroll down to the bottom to see the image... and the outline of the legs isn't very clear. The legs are sort of blurred together. I had tried lowering the CCD offset in the part definition to -50, but it still looked bad. Could this
Electronics Forum | Thu Oct 30 21:06:20 EDT 2008 | ashley
Hello mickd, For Fuji practice, the primary tooling hole preferably be 5mm from the edge of the PCB (lower right hand corner). This is the reference X0, Y0 co-ordinates in the Fuji program where placing co-ordinates going LEFT will be -ve value & go
Electronics Forum | Tue Mar 10 11:23:26 EDT 2009 | vetteboy86
I am setting up a board that is 18.27". In order to be able to reach the whole board, I need to slide the touch stop assembly a few inches further down the slide. After I completed this task, the board will not feed up to the touch stop. The board st
