Electronics Forum | Wed Sep 17 09:33:08 EDT 2008 | vladig
There is one thing you should keep in mind, though. It's better not to have any area of the leads covered with only SAC after re-flow, just to make sure you Sn-whiskers won't have any chance to grow :-) Vlad
Electronics Forum | Mon Sep 22 09:10:25 EDT 2008 | stepheniii
I have a feeling that that software would cost more than his machines are worth. My9, MSH2, and MPA3's are not exactly cutting edge anymore.
Electronics Forum | Fri Sep 26 11:02:15 EDT 2008 | mi
Has anybody heard of the CAM Translator from SMS International? It has support to output to Panasert from different input machines which includes Mydata. http://www.smsinternational.com/handlers/getfile.cfm/4,254,html
Electronics Forum | Tue Sep 16 21:52:19 EDT 2008 | rayjr1491
10x16 by 5 mil stencil gives me a area ratio of .615 unless I am calculating incorrectly. I will try and attach some images tomorrow. By reducing the Y direction my area ratio s below .6 and I thought this was not advisable. Your help is muc appreci
Electronics Forum | Wed Sep 17 18:12:25 EDT 2008 | yam6rider
Ray, 10x16 should give you .62 area ratio, Theoretical Solder Volume=800. You should increase the width and the length to get better solder release.
Electronics Forum | Tue Sep 16 15:23:59 EDT 2008 | bwelch
Does anyone one have any recommendations on type of table top to use for "tabletop" AOI machines. Someone suggested to me of using slate table tops or heavy duty suface tops. Does anyone have any ideas?
Electronics Forum | Fri Sep 19 11:59:57 EDT 2008 | john_smith
Ralph, Is this problem related to all product or is it product specific? You may need to change the fiducial data in the program. I am not familiar with flexa but have some knowledge with MCS30.
Electronics Forum | Fri Sep 19 13:22:33 EDT 2008 | evtimov
Hi, if it is for all your products, for me it looks like a camera cable or camera problem. You are loosing connection and get the message. FFFC looks like a fatal error. If it is only one product, play with the lighting and treshold. Regards, Emi
Electronics Forum | Fri Sep 19 16:33:46 EDT 2008 | mac5
If you're having trouble with a specific board, double check your Pattern, Diameter, Color and Scan Area under the 'Mark Data' tab. You can also try setting the Pitch Tolerance to '0' in the machine configuration. Good Luck, Bill
Electronics Forum | Mon Sep 22 07:30:59 EDT 2008 | jdengler
When our IP-II did strange things we would do a reset start. This fixed a lot of odd behavior. Jerry