Electronics Forum | Tue Sep 23 14:23:19 EDT 2008 | jeffjarmato
Exact Error Message: Following error on Z axis Happens during Homing the machine. Right now as Z Up
Electronics Forum | Tue Sep 23 15:34:59 EDT 2008 | jeffjarmato
Thanks Bob, My email is jarmato@nbscorp.com My mobile phone is 951-216-5060
Electronics Forum | Wed Sep 24 09:53:55 EDT 2008 | jeffjarmato
Morning Bob, Do you have a contact at Tyco for service on this? If you post that I will schedule service and get the tools that I need to get this press running. Thanks, Jeff
Electronics Forum | Wed Sep 24 21:47:25 EDT 2008 | jeffjarmato
To everyone that helped Thank you!!! Got it up and running Thanks Bob, Dean and Bob at Tyco support!!! Jeff
Electronics Forum | Tue Sep 23 18:55:59 EDT 2008 | smt_guy
"Ionization of the air causes an increase in conductivity..." I have an Ionograph and everytime I open the test lid cover the Baseline Stabilization Resistivity Value s by 60M Ohm-cm. My question is: Is there something to worry about our facilities
Electronics Forum | Wed Sep 24 13:49:27 EDT 2008 | slthomas
Is your air dirty or what? I'm not sure what you're asking, actually, but for my money I'd be more concerned with maintaining RH levels at from 40-60% and just keeping dirt levels "reasonable".
Electronics Forum | Fri Sep 26 12:19:09 EDT 2008 | davef
For the IPC Land Pattern Viewer, look here: http://landpatterns.ipc.org/default.asp
Electronics Forum | Thu Sep 25 04:57:51 EDT 2008 | fnorradd
Hi All, I was wondering if any of you have any ideas on what is the optimum angle for the conveyor to pass over the waves on a leaded wave machine ? Any input would be greatly appriciated. Regards Darron
Electronics Forum | Thu Sep 25 17:37:54 EDT 2008 | gregoryyork
Best is 7 or 6.5D if you cant achieve 7. In fact this is the best angle for Leaded and Lead Free, so watch the Chinese machines as they come in around 5 and cause loads of bridging problems
Electronics Forum | Fri Sep 26 12:26:16 EDT 2008 | dwelch123
Isn't that what I just said? Read it again. I said you can swap zero and one OR two and three.