Electronics Forum | Mon Jun 13 12:58:10 EDT 2011 | deanm
We find it is a bigger issue in the summer when there is more humidity in the air even though our facility is air conditioned. We've also seen similar boards go through the same process and vendor A has problems and vendor B doesn't, so fabrication t
Electronics Forum | Fri Jul 22 11:10:27 EDT 2011 | ccouture
It's actually a "silane" according to the same article. Also, it "bonds" with the surface of the stencil. once bonded, it's not going anywhere. I'm not a chemist. I'm not promoting this product to be used on stencil. I'm just pointing out that what i
Electronics Forum | Fri Jun 24 11:14:59 EDT 2011 | williamaxler
My company is currently looking for a closed loop system that we could use for batch washing of PCBs. We primary use no clean flux and are looking for a system that we can use to clean the residue? Most likely we are going to have to add an additiv
Electronics Forum | Wed Aug 03 11:07:29 EDT 2011 | cyber_wolf
IP3 camera calibration requires someone that knows what's going on to do it. Unless you have been trained on this specifically I would recommend that you don't attempt it by yourself. I believe the button jig is used for squaring the camera up. You
Electronics Forum | Wed Aug 03 16:58:19 EDT 2011 | pmdinc
We have a Surf Systems MPC 300 reflow oven that we are trying to keep going as we don't have the money to replace it. Does anyone have a manual or wiring diagram for this machine or one of its close relatives? We would be happy to compensate for th
Electronics Forum | Fri Aug 12 10:10:03 EDT 2011 | rway
I would say you have absolutely no hope of repairing this board. I'm sorry, this is not a knock against you, you just lack the technical expertise to make a go of it. Save yourself some trouble and find a new board or a repair depot that can fix it
Electronics Forum | Fri Aug 19 05:20:40 EDT 2011 | kemasta
Hi! I am searching for a glue type which use for security purpose. The glue must not able to rework after full cure and fast curing time (within 5~10minutes). I have some sample in hand, but it seem quite expensive considering the volume that I am
Electronics Forum | Thu Sep 08 15:05:59 EDT 2011 | shannond
You could always go out on the floor with the tech and do the PM with them. That way you would have 1st hand experience and would be able to offer some creative insight as to how this person could better manage thier time. Or you can post a question
Electronics Forum | Mon Sep 19 23:45:07 EDT 2011 | haiae
I just bought one used Contact 3AV machine and going to calibrate the machine. I just found a problem that I have no tool tips to do follows they instruction. Does anyone who can tell me how to solve this problem. Await for any comment. Thanks in adv
Electronics Forum | Wed Oct 19 20:04:06 EDT 2011 | warwolf
yeah I’ve tried to go down the road of internal recycling but the company carnt justify spending 20k on a machine that does it. Ah but where still onto it in other places though our SMT department has very minimal wastage on solder paste as we have b