Electronics Forum | Tue Mar 27 15:49:54 EDT 2012 | bradlanger
Try Re-seating the card that connects the ISA slot from the computer mother board to the I/O Dpram card. It may be worth checking the ISA card for bad solder joints. The computer mother board could be going bad. Check for vented electrolytic caps. Ho
Electronics Forum | Thu Apr 19 03:06:11 EDT 2012 | roblackey
Hi Gaz, I know it's not the most elegant solution but why don't you just buy 20 tubes of TSSOP logic IC's such as 74HCT27PW (depends on width)- these type of parts are around $0.05 each so you are not going to be paying more than $2.50 for a tube of
Electronics Forum | Thu May 03 15:07:59 EDT 2012 | rodrigo
Hi all, What the largest part I can place with these machines? I'm going to try to install a PLCC68 using the front light because the part is bigger than the backdisk and I want to make sure it can handle it. The part is about 30mmx30mm. Thanks
Electronics Forum | Tue May 22 14:30:54 EDT 2012 | davef
There is no standard, nor should there be. You need to establish a standard that meets your customer requirements. The problem with those old-timey standard is that there's just so many choices. What works for you just might be too strict [or loose]
Electronics Forum | Fri Jun 01 16:13:45 EDT 2012 | kahrpr
You also need to get with the PCB manufacturer. Their is a lot that can go wrong with that many layers. If the manufacture is trapping that much moisture. you may have a hard time baking it out. Dave and Graham are right about the time and energy. It
Electronics Forum | Fri Jun 08 16:36:58 EDT 2012 | noid
KIC 24/7 has evolved into RPI. Not only will it give you virtual profiles, it also gives you DPMO and yield, based where each board lands in the process window. The good thing about this software, you can go back a year later and look up a specific
Electronics Forum | Mon Jul 02 07:41:08 EDT 2012 | jsolloway
I am going through the process of re-evaluating our AOI systems. Depending on the complexity of your assemblies, I would recommend Mirtec's, and aoi systems as the previous post suggests. Had a demo from them a month or so ago and for the price the
Electronics Forum | Thu Jun 21 08:15:25 EDT 2012 | williamaxler
We are going to be changing the layout of our production area and we wanted to rent or buy some air bags / air casters to help us move some of the equipment around. Does anyone know where we could rent these? Or buy? Also does anyone have any other
Electronics Forum | Fri Jun 29 13:50:15 EDT 2012 | tbouslog
We are having some problems with parts that are glued on untill our PCBs go to wave coming off. We would like to test the stenght of the glue. Does anyone have any ideas on how to test pull off strength, torque strength, and push off strength? Any in
Electronics Forum | Mon Jul 16 07:10:09 EDT 2012 | mccabekev
I have found that Edding do an aerospace marker, which is water based and does not run with the conformal coating. However, this washes off prior to the coating so it is not much use. Looks like we are just going to have to put some clear tape over