Electronics Forum | Sat May 18 10:21:09 EDT 2013 | davef
isd.jww: Comments are: * Current thinking has flux volatiles being the major contributor to voiding, not scavanging by via * I have no reason to think that 0.3mm via won't gladly accept solder. Plug them, if that's a concern. * If your concern is ina
Electronics Forum | Thu Aug 29 15:09:23 EDT 2013 | bvdb
Hi, Yes, there is a board marked "Memory Board" but it does not actually contain any memory. The memory card is attached to the CPU card. The board marked "Memory" is a board that allows you to plug in a Compact Flash (CF) memory card which we do
Electronics Forum | Fri Sep 06 14:03:18 EDT 2013 | horchak
If you are a CEM you are setting yourself up for failure and will be left holding the bag. Flash gold has one purpose. It is a protective coating for the base medal to keep it from oxidizing. It is very thin and will be absorbed into the solder joint
Electronics Forum | Mon Sep 09 11:18:23 EDT 2013 | shirjer
We have a Vansco system on our 2005 Alpine Coach motor home. We have an intermittent outage problem with the 12V lighter socket. I can plug something in, like the tire sensor monitor, or the GPS, and after I remove it, the outlet no longer works, n
Electronics Forum | Mon Oct 28 08:27:53 EDT 2013 | emeto
There are many profilers(physical devices) on the market. Most of them have software that makes predictions based on information about the paste, oven model...., but I wouldn't trust the predictor as on your boards you will have different parameters
Electronics Forum | Mon Apr 28 15:20:50 EDT 2014 | davef
Your customer is correct. Your supplier has clamped some sort of machine to your butt and has plugged it in the wall outlet. Honest mistake: * IPC-A-600H, 3.3.2 Lifted Lands - (Cross Sections) ... pertains to boards that were cross sectioned after t
Electronics Forum | Tue Jul 29 17:59:53 EDT 2014 | guts1872
I have had to flush the ram when replacing a TEP controller. These are kind of scetchy instructions from my notes, never could get PPM to send me any procedures. Hope this helps. Plug keyboard and monitor into RT computer and navigate to 2kla/RT/TEP
Electronics Forum | Wed Dec 23 15:35:18 EST 2015 | taborheiking
So I'm in Maintenance and I've been getting a lot of component feeder magazines back that have faulty circuit boards etc and I was wondering if there was anyone out there who has made a desk top test fixture for any of the Agilis or TMD Magazines or
Electronics Forum | Tue Feb 16 14:04:10 EST 2016 | tsvetan
We are designing board which have to plug in M.2 connector and thickness is limited to 0.8 mm The board is very complex with many BGAs and DDR3 memory chips and we will need 6 layers for routing. The problem is that we will need signals with 50, 90
Electronics Forum | Mon Aug 22 08:54:15 EDT 2016 | bobpan
More than likely the encoder scale or read head has an issue. Many times.. oil/dirt/water get on the scale and cause a bad spot or bad area. Try to clean the scale with a lint free cloth and alcohol. You should also be able to see the read head and m
