Electronics Forum | Wed Feb 17 14:04:43 EST 2021 | spoiltforchoice
I suppose you could line up one reel per gantry if you have one of those 4 gantry chipshooters that knocks out 200Kcph...
Electronics Forum | Fri Jun 16 17:42:40 EDT 2023 | robertobsuinc
Hi, Is there any accesory we can get from my data to place caps vertical on the board but are horizontal in the reels? Is taking to much time hand placing the parts, we would like to automate
Electronics Forum | Fri Oct 04 16:07:59 EDT 2002 | ksfacinelli
I was interested in hearing about the different techniques companies are using for keeping track of reels. I will start by saying if you have a small number of feeders and part numbers this may not seem to be a big deal but in many larger OEM's the
Electronics Forum | Mon Jun 23 14:25:24 EDT 2003 | govi
Hi, I am a grad student workin on SMT placement optimization and i am exploring the possibility of utilizing unused slots and assigning multiple feeder slots for a component type on a chip shooting machine. so far my optimization model has shown very
Electronics Forum | Fri Sep 01 22:44:47 EDT 2006 | dmfausti
I have just been engaged again in SMT pick-n-place machines. My latest exposure is with Yamaha YV100 and YM84. I have been having some problem on feeders, especially on 1206 reel packages and above. The plastic cover on the reel does not peel off eas
Electronics Forum | Wed May 09 17:49:16 EDT 2012 | dyoungquist
We run a Mydata high mix, low volume line. You can handle strips with either the Agilis feeders (losing the first 5-10 parts) or by placing the strip on the Y or tray wagons. For cheap parts like resistors, capacitors, some diodes and small ICs, ou
Electronics Forum | Fri Feb 11 00:51:22 EST 2005 | darby
We took our top 25 usage components on our top 10 production models and changed to 13"reels (8mm tape only). When we had 20 parts per we put 2x13" reels on when we had 30 parts per we put 3x13". On those particular products we went from changing up t
Electronics Forum | Fri Nov 06 13:06:39 EST 1998 | Bob barr
What are you people using to store component reels and tubes in? I am looking for a cabinet with slots or something to store reels and tubes. We keep our components on the production floor near the machines. The cabinets we are using now are very
Electronics Forum | Fri Nov 06 13:26:31 EST 1998 | Bill Herman
| What are you people using to store component reels and tubes in? I am looking for a cabinet with slots or something to store reels and tubes. We keep our components on the production floor near the machines. The cabinets we are using now are ver
Electronics Forum | Thu Sep 19 14:25:30 EDT 2002 | stepheno
Changing the pitch on the newer feeders is a little bit different and involves adjusting the location of a sensor. Where we lose the parts is at change-over. There are some reels that we might put on and take off a feeder 20 times before the reel is