Electronics Forum | Thu May 28 13:24:59 EDT 2009 | vetteboy86
Thanks for all the replies. I guess my next question would be regarding software upgrades. The newest software probably wouldn't work, but is there a point at which we can upgrade?
Electronics Forum | Fri May 29 00:34:17 EDT 2009 | operator
Thank you Dave. I have searched the internet and cannot find any literature to the fact. Do you have knowledge of of any articles, whitepapers, etc... Thanks again, B
Electronics Forum | Mon Jun 01 08:12:06 EDT 2009 | davef
If the operator has zero charge and the board has a 10kv charge, when the operator pulls the shorting strip from the edge connector after the coating has cured, there is a large potential for ESD induced damage.
Electronics Forum | Fri May 29 23:11:08 EDT 2009 | isd_jwendell
Have you tried different board orientation through the oven, or have the boards been put through the same way each time?
Electronics Forum | Mon Jun 01 17:49:39 EDT 2009 | gregoryyork
Sorry looking at your profile again and considering its Aluminium substrate I would opt for an increase to the preheat or introduce a soak to the profile to get the PCB up to reflow. Try soaking between 175 - 200C sufficient enough to heat the whole
Electronics Forum | Wed Jun 03 15:28:24 EDT 2009 | mrduckmann2000
Try Fineline Stencils, they help us all the time. They are the experts at what they do, they will help you with stncil thinkness, app sizes and the ratios needed for a great print.
Electronics Forum | Tue Jun 02 21:13:08 EDT 2009 | kircchoffs
thanks for the inputs. we are planning to run on fuji nxt i think cycle time will not be an issue. i still have another question if we can still use the same reflow profile for paste? or do we need to create another profile?
Electronics Forum | Thu Jun 04 19:53:44 EDT 2009 | davef
For low volume work and repair, just use a brush dipped in tacky flux to apply flux to the ball array.
Electronics Forum | Tue Jun 02 08:47:07 EDT 2009 | jhowrylak
I have a operational Omega Meter 600 that I am looking to part ways with. Let me know if interested.
Electronics Forum | Tue Jun 09 22:51:08 EDT 2009 | davef
We don't know the answer to your question, but this paper may help point you in the correct direction http://www.hp.com/packaging/misc/Presentation/AHPStudy.pdf
