Electronics Forum | Mon Aug 16 20:50:05 EDT 2010 | adhesivedispenser
CiXi Tian Hao Electric Technic Co.,LTD manufactures adhesive dispensing equipment and may be able to offer assistance with your application. Check out our product information at http://dispensing-th.com. We manufacture dispensing equipment ranging fr
Electronics Forum | Sat Aug 21 02:27:21 EDT 2010 | isd_jwendell
The paste you dispense will not solder the same as the one you use with a stencil. The paste for the stencil will have a higher metal content. I was not working with dispensing as small as you are, but after evaluating the cost of the stencil vs. lon
Electronics Forum | Tue Aug 17 10:26:26 EDT 2010 | quest@fr
Our customer ask us how many repair (component removal, change and soldering) we guaranty for SMT components on our printed wiring board. We all have the number "3" in mind but we can't justify it by a standard. We can't reply "state of the art". Doe
Electronics Forum | Thu Aug 19 15:26:34 EDT 2010 | namruht
Thanks everyone. I have thought about the moisture in the paste a lot, but never really gave the raw card moisture any consideration. The next time we run an assembly with the issue I will try baking some of the cards once the issue shows up to see i
Electronics Forum | Wed Sep 01 05:09:27 EDT 2010 | grahamcooper22
Dear SMT Manufacturer, I am wondering if the device could have so much moisture in it and storing it in a dry cabinet isn't going to remove it all. As a final test to see if moisture in the device is causing the voids/solder balls then I'd bake it a
Electronics Forum | Thu Sep 02 07:50:27 EDT 2010 | sachu_70
Just to add to my comments,solder joint voids do occur in LGA. Voids in LGA can be larger due to geometry and greater ratio of flux to solder. IPC-A-610D specifies a greater than 25% voided area is a defect for BGA, however, it does not specify the d
Electronics Forum | Wed Sep 01 14:59:12 EDT 2010 | eezday
I've been working to bring a Universal GSM-1 back to operational readiness at a university. I have lots of pnp experience but little on the GSM. The software is at 3.2.3. When I try to manually "zero the board" in the PWC menu I get only a black s
Electronics Forum | Thu Sep 02 15:01:52 EDT 2010 | James Neal
Manufacturing-wise, is there a problem with doing a single panel with both four layer and two layers designs on it? I do prototype runs with multiple designs on the same panel, and I'd like to start including four layer. It seems to me that I can g
Electronics Forum | Thu Sep 09 13:25:22 EDT 2010 | eezday
I've seen the purple silkscreen before on ENIG board built with PbSn process. I would think that if temp is the issue the lower process temp would not have caused the purple ink. I remember that the flux I used was water soluble and I attributed th
Electronics Forum | Wed Sep 08 07:49:01 EDT 2010 | vleasher
We are a CM looking to do some low volume taping for the purpose of getting some undesirable parts out of track feeders. We don't always buy in the volume to get reel and it seems some components ie.Maxim only seem to come in tube. Is it typical for