Electronics Forum | Thu Aug 24 19:26:07 EDT 2006 | darby
Dave, Cygnal was taken over by Silabs. I based my design on the second link that you provided. Tell me folks, are you using one large pad with only the stencil having the grid, or are you actually breaking up the large pad into grids with mask around
Electronics Forum | Tue Aug 22 15:57:17 EDT 2006 | slthomas
As far as room goes, I have to talk my boss into getting rid of some other crap around here before looking at the Mydata. The room is there, it's just occupied by stuff we NEVER use. My understanding of the TP-9 is that it's considered flexible but
Electronics Forum | Wed Aug 23 08:08:25 EDT 2006 | aj
There are a few variables that you have to consider : 1. Hours available on Wave Machine ( are other products going thru the same wave) 2. What beat rate are the boards being supplied from previous station?i.e. do you envisage the waveto be a bottl
Electronics Forum | Tue Aug 29 11:34:42 EDT 2006 | pr
WOW, for having never spent more than a drive by with the units and NEVER having set it up or used it, you are a wealth of info. who say's you can't learn anything from the fine smtnet archives? You definately have bean bags on the chin (mind) cause
Electronics Forum | Thu Aug 31 21:43:13 EDT 2006 | fastek
I don't sell them for $25K either but my point is they can be had for that price. In fact the last (2) that I had I purchased for $8K and $9K. I never have claimed to be the cheapest dealer around and it's not my intention......I only intend to be
Electronics Forum | Tue Sep 12 10:55:29 EDT 2006 | slthomas
I found this searching the archives. Unfortunately Bob doesn't seem to have an active site anymore, just references by people he works for. It's a shame, because there was a load of good stuff there. Haven't looked at Phil's site for a while but it's
Electronics Forum | Wed Sep 20 10:36:27 EDT 2006 | proy
I am considering moving my spray fluxer into a completely separate operation. Has anybody any comments of sraying VOC free flux on boards, then putting them in a drier/holding rack for possibly say overnight, then running them through wave solder?
Electronics Forum | Tue Sep 26 09:57:19 EDT 2006 | daxman
Thanks Chris... I do not have the c-tool, but I did make some adjustments to the middle cube when I was calibrating it. Like I said in an earlier post, I cleared the vision offsets in the ap.cal file and adjusted the middle cube until the board alig
Electronics Forum | Tue Oct 10 16:04:45 EDT 2006 | slthomas
*and* board repair, does anyone know where I can get (optimum resolution) an economical repair on an ICOS MVS 100/32 vision card, or (next best thing) a schematic for it? Tyco can't provide a schematic because they don't have one (proprietary techno
Electronics Forum | Sat Oct 28 22:06:12 EDT 2006 | mika
Haha, I have to totally agree with the prior posting! I think it is somewhat strange sometimes when a salesman think it is ok to "black list" their competitors! We had a sales guy from a "company I prefer not to mention by name, but obviously You