Electronics Forum | Sat Feb 27 16:54:29 EST 2010 | deltaservices
sent me your mail adress and i'll sent you cad2cad
Electronics Forum | Tue Mar 23 05:57:48 EDT 2010 | mun4o
Hi, can you send me cad2cad software??We have 2 machine Topaz. Regards.
Electronics Forum | Tue Mar 23 12:27:21 EDT 2010 | deltaservices
I have 1.5 available, send me your email adress and i can forward it to you
Electronics Forum | Fri Jun 04 14:04:36 EDT 2010 | dedwards
I have a question about assembleon vibration feeders. What is the process for loading tubes in these feeders? Our personnel are cutting the top of a tube end around the size of the part and glueing it into place. Then the machine is programmed for
Electronics Forum | Fri Jun 04 14:08:59 EDT 2010 | deltaservices
I guess you mean the stick feeder. Most operators, just hold the new stick behind the one that is on the feeder and let the components slide over into the old stick. However, stick feeders are the worst way of feeding components.
Electronics Forum | Tue Jun 08 08:32:47 EDT 2010 | deltaservices
Hello Nguyen, You calibrated the Eclipse (with glass components I gues, on the glass PCB. After that you have to run the Chip calibration that calibrates the laser offset. You can also manually put in a laser ofset but this is not so accurate.
Electronics Forum | Tue Jun 08 08:32:54 EDT 2010 | deltaservices
Hello Nguyen, You calibrated the Eclipse (with glass components I gues, on the glass PCB. After that you have to run the Chip calibration that calibrates the laser offset. You can also manually put in a laser ofset but this is not so accurate.
Electronics Forum | Fri Jan 29 02:59:02 EST 2010 | szsummersun
hi peter, i have experience with manual soldering iron using automated wire feed,please email to me about it in detail,thank you.email:steven@ludeecircuits.com
Electronics Forum | Wed Jan 06 15:25:35 EST 2010 | wolverine
Any help would be appreciated We have a DEK 265 Screener that has been showing symtoms of a bad power supply. Is there a way to back up the hard drive and is an executive program needed in case the machine totally dies. Dave
Electronics Forum | Thu Jan 07 09:58:14 EST 2010 | kjs123p
Pull the hard drive out and use a USB to IDE adapter to copy the whole hard drive onto another computer. I do this with my reflow oven and screen printer. It works very well.