Electronics Forum | Wed Nov 15 13:44:32 EST 2006 | sliebl
Paul, That's what I thought you were going to say. I can do the same thing with my Contact machines, although I do not have feeder handling carts to pull entire banks of feeders, it would have to be done individually. Even though we are a small to mi
Electronics Forum | Wed Dec 06 17:23:40 EST 2006 | jamyboy
Steve, Although you probably have an answer by now. CircuitCAM can generate programs for you machines no matter how many you have, in 2 different ways 1 is free the other cost money. THe first is the easy way, setup you factory model to imitate
Electronics Forum | Tue Nov 21 12:35:59 EST 2006 | CK the Flip
It probably depends on the Silver content. We are also using Sn62Pb36Ag2. The paste manufacturer told us that the reason for the small silver content was so that it could wet better to the lead-free component and board finishes bearing silver.
Electronics Forum | Thu Dec 21 21:37:19 EST 2006 | Jack
Hi Pavel, Real Chunks, Thanks for your valuable inputs..Selecting the correct location for board profiling is critical in determining the solder joint quality. Am I right to say TC wire attachment locations priority should be as below: (1) Thermal
Electronics Forum | Thu Jan 04 15:39:49 EST 2007 | realchunks
Is it a failure or a schedule overdue? If it's a failure check the vacuum sensor in the exhaust. You should be able to locate the straw and follow it back to the diaphragm. You can adjust the diaphragm. Or you can electrically jumper past it.
Electronics Forum | Thu Jan 04 13:22:31 EST 2007 | patrickbruneel
Yes Samir I�m aware of this, but thanks for reminding me. I posted this in Oct 2006 http://www.smtnet.com//forums/index.cfm?fuseaction=view_thread&CFApp=1&Thread_ID=10978Message44694 This is not going to affect us much because China is more expor
Electronics Forum | Wed Jan 17 11:43:14 EST 2007 | stepheniii
The dumbest thing I read was the response to me saying people should not automatically send product to China. I was told not to bury my head in the sand. A lot of companies are being lemmings and taking it for granted it's best to send a product to C
Electronics Forum | Wed Jan 17 17:17:21 EST 2007 | russ
i would say that you are there already. with 10,000 DPM0 you have a 1% fallout, you are at 99.9 basically. 1 out of a 1000 boards will fail? of course one thing we need to know is how many opportunitites do you count for a chip resistor for exam
Electronics Forum | Thu Jan 25 12:15:08 EST 2007 | James
Does anyone have a recommendation for a good OA Pb-Free Paste? We are currently doing Pb-Free with a No-Clean that we are very happy with but we are going to start coming out with products with RF and I have researched that No-Clean residue and RF d
Electronics Forum | Wed Jan 31 17:30:54 EST 2007 | GS
Thanks a lot flipit, I am not directly involved in this "problem" but is my friend that have his CM rejecting PCBs because it says the "+" mark (spokes lengths) are out of tolerances. It seams CM bonder's require tolerance +/- 0,05(? not sure). I d