Electronics Forum | Fri Feb 05 11:56:58 EST 2010 | kjs123p
It should show up as a mass storage device. Not to insult you intelligence, but do you have the hard drive powered up? You need to power it up if you haven't done that.
Electronics Forum | Thu Feb 18 20:19:42 EST 2010 | dekhead
Don't know if you managed to get this sorted; but at the very least need to backup your configuration (c:printerconfig.cfg) to FDD to avoid having to recalibrate entirely if it fails. If you're still having issues with Xcopying HDD feel free to conta
Electronics Forum | Sat Feb 20 20:45:53 EST 2010 | dekhead
Sounds like you have a Switched 12V issue. Breaker on rear of Machine. Fuse in Y1 enclosure. PSU3 (on floor of) Y4 enclosure.
Electronics Forum | Wed Jan 27 20:11:36 EST 2010 | plerma
What material is used to cap a via? Is it the > standard LPI Process/Material? we tent vias all the time, mostly to assist with assembly and the majority of the time outgassing is not a problem. What is the purpose in your case?
Electronics Forum | Thu Jan 07 13:52:28 EST 2010 | empac
Hi, I am looking for the following: Y actuator and P/N : 140377 for DEK265LT. Let me know if you have this part available. Thanks. Bob
Electronics Forum | Fri Jan 08 02:25:42 EST 2010 | graceytiu07
Happy New Year to All: Has anyone of you encountered a solder short on QFP pin yet there's no evidence of bridging in between gaps? I am using an SnPb solder paste.
Electronics Forum | Fri Jan 08 21:34:44 EST 2010 | isd_jwendell
Not specific to QFP, but I had a run of poorly etched boards. I could see the short using 75X magnification with back lighting, but only some of the time. Nasty little shorts on ~25% of the boards that cost us a boat-load of cash.
Electronics Forum | Fri Jan 08 22:39:22 EST 2010 | graceytiu07
Thanks for the reply. I'll try your suggestion. I tried the SEM EDX to check for traces that might cause the bridging problem but it looks normal. I haven't tried yet the material level analysis of the QFP. Thanks again.
Electronics Forum | Mon Jan 11 14:51:11 EST 2010 | davef
If you don't have bridging between pads, how do know that you have a solder short, as compared with some other type of short?
Electronics Forum | Tue Jan 12 02:43:20 EST 2010 | graceytiu07
To cbart, The units are from our testing center. Actually I also suspected that it is a board issue. But i dont think its possible for 2 suppliers of board to have same problem. I am also checking the possibility of problem on QFP. Thanks for the s