Electronics Forum | Sat Mar 21 16:33:09 EST 1998 | Earl Moon
| | | Cpk's on top flight ovens (e.g., Conceptronics, Heller, Electrovert, Vitronics) vary wildly, from 1 to 2+, between different supplers. The suppliers don't seem to understand Cpk's. A supplier's rep whose oven has a Cpk of 1.0 told me: | | 1.
Electronics Forum | Sat Mar 21 16:37:22 EST 1998 | Earl Moon
| | Cpk's on top flight ovens (e.g., Conceptronics, Heller, Electrovert, Vitronics) vary wildly, from 1 to 2+, between different supplers. The suppliers don't seem to understand Cpk's. A supplier's rep whose oven has a Cpk of 1.0 told me: | | 1. C
Electronics Forum | Wed Aug 08 21:18:15 EDT 2001 | davef
Get-out the razor blades, bud. You could run that sukka for 6 sec dwell, cook breakfast on it, and you still will not get fill. [Hole file that is, breakfast will go along ways if peckish, though.] You could fire-up the depleted ozone rework gun [
Electronics Forum | Fri Oct 19 17:41:21 EDT 2001 | Stefan
I used to love tweaking. I tweaked and tweaked until I got a master degree in tweaking. But than I had to teach others how to program a board and avoid tweaking. After all it does not go quite conform with ISO and other quality approaches. I investig
Electronics Forum | Fri Nov 23 05:52:45 EST 2001 | Wolfgang Busko
What Claude is saying may be right. But looking at it a bit different from the view of "senior management" this should be interpreted as depending on the salary the work itself is different and therefore the responsibility is different. It doesn�t na
Electronics Forum | Wed Mar 27 16:54:47 EST 2002 | davef
STARTING RANGES * Pressure � 1 pound/inch of blade (metal); 1.6-3 pound/inch (plastic) * Speed - 0.5 to 3 inch per sec [for standard pitch]; 0.5 to 1 inch per sec [for fine pitch] Your paste supplier�s recommendation is a good place to start. * Sepa
Electronics Forum | Tue Jul 09 15:20:19 EDT 2002 | pjc
When you look at the capabilities of Combo machines they tend to sacrifice performance when compared to separate X-ray and AOI machines, meaning they don't do either the X-ray or AOI operations as well as a machine that was designed to do only one. A
Electronics Forum | Thu Aug 01 13:10:46 EDT 2002 | johnw
Chris, I don't know what machine your using, but we're also playing with one at the moment and don't see any problems with micro solderballing as far as I'm aware (I'll double check tomorrow thou!) We're using Kester 977 with it and don't have a pro
Electronics Forum | Mon Oct 28 08:05:41 EST 2002 | Bob...
Not saying anything new here. I agree with all the comments posted. I have worked in the industry for over 20 years and have experience on all but Mydata. Which machines are you looking at? Fuji CP3’s were too maintenance hungry, CP4.3’s bullet pro
Electronics Forum | Thu Dec 26 16:51:47 EST 2002 | davef
First, an earlier poster suggested using DI water. We are NOT excited about DI water with a NC fluxer, unless DI water is the proper flux thinner. Second, as you inplied, the maintenance steps you take should vary according to the amount of time th