Electronics Forum | Tue Aug 15 08:49:13 EDT 2017 | kalsi311
Yes Evitmov, you can say I am more comfortable with mirae machines then advantis. I just want to know if somebody worked on MR series mirae machines and Fusion UIS machines so he can give me an advice witch one is better. Definitely I will not buy mo
Electronics Forum | Thu Aug 10 13:27:29 EDT 2017 | dilogic
I prefer simple sequential P/N system. We use digits 0-9 and english aplhabet (total of 34 characters). Letters I and O are ommited to avoid mix-up with digits 1 and 0. P/N is 6 characters long - long enough to cover ~1.5 billion parts but short eno
Electronics Forum | Thu Aug 17 12:18:40 EDT 2017 | cyber_wolf
I do not see anything obvious that would cause a thermal mis match. Regarding reflow profiles reducing tombstoning, Unless there is something wrong with your paste or you are running smaller than 0402's, I have NEVER seen a reflow profile reduce tom
Electronics Forum | Thu Aug 24 23:20:22 EDT 2017 | micropak
We often do double sided SMT assembly, never had issues with smaller components. However, we apply glue to heavier components like inductors, SD card sockets etc. For this purpose, we have a glue dispensing machine inline after the solder paste prin
Electronics Forum | Thu Aug 17 21:56:05 EDT 2017 | v037022
Dear experience members, Now we are using permelex squeegee blade and we do cleaing it after printing 24 hours. Actually, it took very long time to clean. we need to take out one by one screw and use bemcot paper/ alcohol to clean solder remaining on
Electronics Forum | Sat Aug 26 03:12:27 EDT 2017 | ausplex
Hi, We have a Juki KE-730, and was looking to buy a Zevatech KE-730 has a backup and for spares. We thought these machines would be identical, however when we looked at the circuit cards we noticed the image processing cards were quite different. I
Electronics Forum | Thu Aug 31 14:33:40 EDT 2017 | dcook81
I am looking to build a prototype for an idea that I have and not sure where to begin. I am looking for electronic parts (SMT?, microchip?...not exactly sure on terminology) that can communicate with each other via a transmitter/receiver relationship
Electronics Forum | Tue Sep 05 10:14:41 EDT 2017 | swag
Try a fid teach on your changers. I don't recall how to do it but you'll find it pretty easy if you surf around. Also, the seals on the nozzles must be good and soft. If you can still get them new, I'd replace. Same goes for seals in changers. C
Electronics Forum | Tue Sep 05 05:25:27 EDT 2017 | heros_electronics
Hi, I think your friend wrongly changed the D code so that the finger width doesn't meet your requirements. And the fingers have long and short ones, which is hard to do selective gold plating because of not easy to add plating wires. Of course, you
Electronics Forum | Tue Sep 05 14:31:42 EDT 2017 | rgduval
Create a package, set the mechanical centering to the dimensions of the 8-DFN that you're trying to place, test the centering. Tweak the dimension that's failing. Shouldn't be too much of a problem. An 8-DFN package is nothing more than a rectangu