Electronics Forum | Mon May 06 19:21:39 EDT 2013 | amelby
We had that problem on our M12. There were a few > components that had gotten dropped into the > camera area as the hydra head past over it. Our > MY12 has a knob towards the front of the machine > in direct line with the camera. Pulling this
Electronics Forum | Fri May 02 14:30:48 EDT 2014 | jimmyboz
The last 3 posts were quite refreshing. I never said, but, I may have implied that "no tools necessary" is OK. No way. I honestly lost sleep over this thread. I was kinda playing "devil's advocate", but man what a response. I have been on every s
Electronics Forum | Mon Feb 16 10:33:58 EST 2015 | rgduval
Drilling a hole, and attaching the thermocouples underneath the part is the recommended way to profile for a BGA, unfortunately. It allows the best method of collecting specific data, including any thermal sinking/shadowing that the BGA creates. Ho
Electronics Forum | Tue Sep 15 14:11:59 EDT 2015 | jpal
You should also remove all the pump parts and clean them, checking the bearings and seals. Clean completely the parts that allow the solder to flow back into the pot; ours have a spiral that fills with dross. Treat yourself to new nozzles. Tinning
Electronics Forum | Mon Jan 23 21:56:50 EST 2017 | jgo
Hi all, Am new to the SMT process. I'm in the process of purchasing a new SMT Pick & Place machine and am trying to figure out how to perform the buy-off. I'm from the semiconductor packaging background. For any new machine purchase, I'm used to se
Electronics Forum | Thu Feb 15 02:19:50 EST 2018 | Robl
Hi Leadthree, We have a combination of methods depending on volume, value, size, level of build, and what the customer does with them. So on high volume low value we have rigid plastic ESD boxes with lids, foam lined, that layers of custom vac form
Electronics Forum | Tue Aug 27 02:55:43 EDT 2019 | oxygensmd
I am looking for a simple software which I can use in my production. I have the following task which I would like to solve with this software: - Components storage: counting the components in my production area. I would like to store their following
Electronics Forum | Tue Jan 31 18:50:01 EST 2023 | markhoch
You might want to look into the Vorne XL Productivity Appliance. You connect it to your line by connecting it to a sensor that will trigger an input. (I used the exit sensor on the pre-reflow conveyor). It's probably the most cost effective productiv
Electronics Forum | Wed May 17 11:19:44 EDT 2000 | John Thorup
Hi Dave It sounds like you do pretty much what we do. A couple of points: If your machine allows, open, fill and seal the dross container inside the machine. Otherwise, the auxillary exhaust as you describe is a must. Be gentle in your movements. Don
Electronics Forum | Thu Mar 25 14:13:13 EST 1999 | Bob Willis
| | I am looking for clip art images of electronics assembly. Images like wave soldering, surface mount components, soldering irons... just general assembly graphics. Many sites have different individual images that they use I was just wondering if
