Electronics Forum | Sat Feb 19 10:07:51 EST 2011 | kahrpr
What kind of voids? There are voids from out gassing (moisture) and voids from contamination and or poor solder ability ? If it is on one component I would look at the part. Also if it a big Varistor make sure the board is preheated properly.
Electronics Forum | Wed Mar 02 08:25:34 EST 2011 | rway
Look at your fluxer as well (spray or foam?). You may not be getting ample flux over certain areas of the board. This can cause voids.
Electronics Forum | Wed Mar 02 09:13:37 EST 2011 | aribeiju
I guess the problems are about humidity. How much time before production we need to store in Dry Unit? We have the SD532-31 SUPER DRY gabinet and we will use to store the PCBs. Thank you for your answer.
Electronics Forum | Mon Feb 21 00:35:42 EST 2011 | dman97
The Fuji CP6 and QP242 should be more than capable of placing 0402(cp6) and bga components (QP242). You must be having some programming difficulties.
Electronics Forum | Thu Mar 10 06:51:26 EST 2011 | ravo
no my dear, CP6 vision not able to verify but it can pic up it, and qp242 will be extremely slow
Electronics Forum | Thu Mar 10 06:57:02 EST 2011 | ravo
yea SR.TEC, am suffring right now from trying to assemble BGA 676 pins with my QP242
Electronics Forum | Mon Feb 21 20:20:01 EST 2011 | proy
I have a 1996 Camalot 1818, and somebody has broken the nozzle 'flat' tab on the auger body. Does anyone have a parts machine around? PR
Electronics Forum | Mon Feb 21 20:22:29 EST 2011 | proy
I have a 1996 Camalot 1818, and somebody has broken the nozzle 'flat' tab on the auger body. Does anyone have a parts machine around? PR
Electronics Forum | Tue Feb 22 10:17:11 EST 2011 | huei23
Hi everyone, Our FA team recieved the defect unit from our customer, and the issue is GF discoloration. EDX was conducted and Na element was detected on the discolored area. We're currently working with the customer to determine the rootcause. Pleas
Electronics Forum | Fri Mar 04 18:08:26 EST 2011 | eadthem
There is a option to enable no good marking that must be enabled on the board options where you reset your board count and images. dose the marker zero on startup?. If not then it may also need enabled in the inspector settings. ead
