Electronics Forum | Wed Dec 24 15:28:17 EST 2008 | edmentzer
We use SN100C for wave soldering and hand Lead free soldering and have had very good results. The wire cored solder for hand soldering flows good and makes very good solder joints. The SN100C in the wave solder machine also works very good. We use
Electronics Forum | Thu Dec 16 15:06:32 EST 2010 | rway
I would go with AOI. Reasons are: --AOIs are faster --They have more coverage. Given, you cannot test the value of components, but the AOI will ensure that all resistors are correct, orientation of ICs are proper and components are present on the
Electronics Forum | Tue Feb 08 10:25:46 EST 2011 | remullis
Michelle, It's been years since I worked on these machines and mine were CS400E's. The next time this error comes up instead of powering down Unplug the RS232 cable that links between the PC and the processor board in the machine, I cant remember if
Electronics Forum | Mon Aug 08 16:14:36 EDT 2011 | wmburke
We are building a plasma diagnostic to monitor MHD phenomena in tokamak. As part of the development, we need high-voltage, high-power RF capacitors to tune and match an inductive load. This application is similar to a small induction heater, with t
Electronics Forum | Sat Jun 08 13:16:06 EDT 2013 | unisoft
Take a look at the Unisoft software ( http://www.unisoft-cim.com ). For over 25 years this software has in use by Electronics Manufacturer CEM/EMS's and OEM's to automate New Product Introduction (NPI). It's perfect for Electronic Contract Manufact
Electronics Forum | Mon Mar 30 11:02:37 EDT 2020 | SMTA-Eric
As we navigate through the CORVID-19 pandemic, many essential manufacturing facilities are still on line and operating. Some at reduced or modified schedules in following the guidelines to help reduce the spread of this virus. My question is in rega
Electronics Forum | Fri Nov 06 20:43:58 EST 2020 | jmelson
Does anyone have schematics for the PC board inside a Quad IQ feeder? I have one that worked a few days ago, but now gives me blinking lights and doesn't move. Or, do you know what to do when it won't move? I have checked the contacts and the feeder
Electronics Forum | Thu Mar 24 23:34:55 EDT 2022 | glasscake
My Koh Young 3030VAL errors on the homing routine. The "DTool" "MCS" gives me an error "Before homing, X-AAxis already checked negative limit..." "Before Hoking, Y Axis already checked negative limit..." "Please turn off the control-power-switch, an
Electronics Forum | Tue Nov 08 10:52:29 EST 2016 | aemery
Tom, Hardware limit means the machine thinks it is at the limit sensor or a particular axis timed out before it got to the home sensor during the reset sequence. Go to your O/I map and see if any of the axis limit sensors are lit. You could have a
Electronics Forum | Tue Dec 05 21:11:35 EST 2000 | Dave F
The CDROM player in my personal computer just died and I replaced it with a more lively unit. Being an inveterate gearhead, of course I had to field strip the old CDROM player as soon as I pulled from my PC [and got the new one running]. There are