Electronics Forum | Wed Apr 19 06:56:54 EDT 2006 | QTEK Manufacturing Ltd. www.qtek.com
QTEK Manufacturing Ltd. provide a solution to the above problem, QTEK Cover Tape Extender adds an extra 380mm to cover the tape of component reels. It saves components being wasted or discard when strating a new tape through a feeder, and enables the
Electronics Forum | Tue Oct 23 22:12:57 EDT 2007 | davef
1 Tape & reel, automatic * RVSI/Systemation ST-60 * Shinkawa SDP-FA-TAPE 1 * V-TEK TM-5100 * Q Corporation QMT-1500 2 Tape & reel, manual * RVSI/Systemation MT-30 * V-TEK TM-50XL * Q Corporation QMT-1100 3 Tape & reel, peel force tester * RVSI/Syste
Electronics Forum | Mon Oct 26 17:04:30 EDT 2009 | stepheniii
IIRC the IPC spec for oven profiling says the thermocouple leads should not be more than one meter in length. I think when you can afford it, getting a data logger to go through the oven would be a good idea. But if you are going to use the very lon
Electronics Forum | Tue Jun 21 15:55:23 EDT 2011 | michael4575
I'm Currently looking for any and all viable options for recycling SMT reels and all associated plastics. Several years ago SemiCycle supported all 3 packaging types, but currently only supports trays. Several vendors will support tray recycling, bu
Electronics Forum | Thu Jun 14 00:18:05 EDT 2012 | tech1
Not trying to be negative but MYplan or MYlabel are not really going to help you with this. The most they will do is tell you what you already know: the reel is on another machine. Instead of dropping 5 to 10k on software think of how many reels you
Electronics Forum | Tue Feb 26 09:32:56 EST 2013 | anton99
Update: We have bought more reels to cover both lines and it has helped enormously. There were about 100 part numbers that were used on both lines over 300 times per year. The majority of them were less than $20.00 a reel. We have also been using My
Electronics Forum | Mon Nov 26 16:07:56 EST 2012 | jerlong
Greetings, Does anyone know where to find a tape and reel flatness specification? Looking at the EIA 481-B standard, there is no reference to the tape flatness (the images shown may "imply" flatness from one side of the tape to the other, However I
Electronics Forum | Fri Apr 10 11:01:44 EDT 2015 | joe98375
Hello, I am looking for a machine that can cut terminals on a reel efficiently. We buy some of our terminals on reel because it is significantly less expensive than buying them in bulk packs even with the added labor of clipping them off one by one.
Electronics Forum | Tue Jul 19 12:36:03 EDT 2016 | jbuckley
My company uses both Juki electric and mechanical feeders. Yes, electric feeders are much more efficient than mechanical as far as pick speed and general feed speed. However, if a reel runs out, it usually takes our operators under a minute to change
Electronics Forum | Tue Feb 20 14:21:54 EST 2018 | deanm
Thank you all for your feedback. While the new smart reel towers are the ideal, we simply cannot afford them or better pnp equipment at this time. However for the short term, probably putting colored stickers on the reel edge folded over so it is vis