Electronics Forum | Fri May 13 17:58:14 EDT 2011 | jbaez1
Hi VicKt! I will check the spindle nozzle changer issue this weekend, and the clutches were replaced since long,long time ago....probably more than 2 years..could be this the cause? for only one spindle? Thanks....
Electronics Forum | Mon May 16 09:54:06 EDT 2011 | vickt
This could be the cause. A simple test is as follows: Turn on the clutch for the specific spindle in I/O and use your hand to rotate the z shaft to drive down the spindle. Drive the spindle by hand to the end of travel and try rotating beyond that
Electronics Forum | Wed May 04 08:17:57 EDT 2011 | leemeyer
Parts that are the same size can share the same extent #. If you are placing 100 different 0805 components you will need only 1 extent.
Electronics Forum | Thu May 05 07:41:19 EDT 2011 | leemeyer
Yes, what you are thinking is correct. Assuming an 0805 capacitor parts that are picked from the front and back of the machine will be picked at 0 theta. Parts that are on the left or right will be picked at a 90 theta. This way they can all share th
Electronics Forum | Fri May 06 07:29:55 EDT 2011 | leemeyer
You got it. You are aware that Quad defines the theta by steps. 0 = 0, 90 = 6000, 180 = 12000 and 270 = 18000.
Electronics Forum | Fri May 06 09:39:26 EDT 2011 | leemeyer
Sorry but I have never worked with a machine that has the Cyberoptics system. Have you tried talking to PPM (www.goppm.com), They have been very helpful to me.
Electronics Forum | Sat May 07 07:03:16 EDT 2011 | jimlas53
Thanks for the suggestion, Bobpan. I'll start looking for a replacement coax cable. Would we be better off to look for a Quadalign system and replace the Cyberoptic unit? Doug
Electronics Forum | Mon May 16 15:00:53 EDT 2011 | bobpan
Sorry about taking so long to respond.......The quadalign is a retrofit. You cant just buy a quad-align and mount it on the machine. There is different firmware,cables,and other stuff. Good luck
Electronics Forum | Tue May 10 12:11:27 EDT 2011 | scottp
Do you have pictures and/or cross-sections of the non-wet? Is the HASL SnPb or SN100?
Electronics Forum | Tue May 10 17:05:14 EDT 2011 | markhoch
I've found Electro-Shock Behavior Modification tools to be quite helpful.... You've got to crank the voltage up a little at first, but once you hit 'em two or three times you can turn it back down.
