Electronics Forum | Wed Jul 10 08:50:02 EDT 2013 | mobe1969
Hi SMTnet Members I'm looking for some help with my Westek ICOM500 Ionic tester. It has been sitting for a while. We want to get it up and running. I don't have any tools with this tester. Do you know what material I need to get this to work? Calibra
Electronics Forum | Wed Jul 17 08:21:10 EDT 2013 | ejurentkuff
My boss wants me to look into a 5DX or equivalent equipment. Right now I am in discovry mode. I need to know what's out there and the pros and cons. What type of support I'm going to need (programming, running, etc.) Cost/benefit. Any information
Electronics Forum | Thu Jul 18 11:59:47 EDT 2013 | justinlevine24
Hi Eric, What ESS test equipment are you looking into specifically? This will allow us to help answer your questions better. Best Regards, Justin Levine OEM Company | Global Sales Division [Office] 408-675-5613 | [Cell] 480-273-6068 email: Ju
Electronics Forum | Thu Jul 18 17:51:13 EDT 2013 | justinlevine24
Yes, I have a few in our system. Send me a message with your needed specs and I can match it up for you. Justin Levine OEM Company [Cell] 480-273-6068 email: Justin.l@oemcompany.com www.oemcompany.com
Electronics Forum | Fri Jul 19 11:50:53 EDT 2013 | rway
Our current machines are rated for 20K/hour. The new ones are 30K/hour, hence the concern with the speed of the F1. Hypothetically, if your machines were running 50% faster, do you believe your F1 would keep up. This is not scientific, I'm just wo
Electronics Forum | Mon Jul 22 15:02:31 EDT 2013 | dyoungquist
What is the pad surface finish on these boards? I know OSP and silver finishes have a shorter shelf life than HASL or gold. We do not use OSP or silver on our boards so I don't know what to look for visually on the pads when they have exceeded the
Electronics Forum | Mon Jul 22 18:46:57 EDT 2013 | jorge_quijano
I've seen the Pick n Place immediatly after the Screen Printer, but they have a good 2D inspection, so the really do not need an operator to inspect or remove any PCB before the Pick n Place, if you have a good Printer I will not foresee any problem
Electronics Forum | Wed Jul 24 12:03:10 EDT 2013 | rway
I agree with JDengler. It is easier to service a machine if there are conveyors between them. You need to also consider how the units get transferred, SMEMA signaling or some other method. Some equipment doesn't support this and an output conveyor
Electronics Forum | Thu Jul 25 16:13:46 EDT 2013 | markhoch
We occasionally have the same issue with ours, but it is caused when the sensor, (that is supposed to detect when the magazine has emptied), has been knocked out of alignment. If you a transmitter/sensor set mounted at the exit end, make sure that i
Electronics Forum | Fri Jul 26 04:21:24 EDT 2013 | chris_flex
You`re right this is also a possible reason. But we have 2 Loaders from 1997 here where the error comes from the plc-program . Although all sensors are working fine the bottom conveyors are always running. We`ve planned to modify the program. BR
