Electronics Forum | Wed Aug 21 17:03:13 EDT 2013 | hegemon
I think your pre-heat temp is a little low for SAC 305 Soldering. Especially with a Pallet. You might want to try to add some time and temp to get the PWB itself preheated up to 150-160C. That should help with the barrel fill. Make sure your board
Electronics Forum | Mon Aug 26 17:07:37 EDT 2013 | mrduckmann2000
Help! I have a MPM AP/A screen printer that when the unit goes through "Reset" at the end of "Reset" it turns on the "Dispense Pinch" and it allows a valve to open and it whistles so loud you can hear it all over the shop. Is there a way to disable
Electronics Forum | Wed Aug 28 20:01:17 EDT 2013 | vinodkumar
can anyone help me how to get Siemens Line computer installation floppies or someone mail me the contents of the floppies of 00345544-01,00345542-01. I assume it is boot disk of 3-4 numbers. Request you to mail it to me or load it to a site and give
Electronics Forum | Tue Sep 24 04:14:25 EDT 2013 | winson16
Hi Joe, first of all thanks for your input. I did tried to search for the Mydata brochure and found that they are using Lifescan Vision System (LVS) which i think should be vision analysis. Appreciate if you can explain more in detail how's the mecha
Electronics Forum | Mon Sep 09 15:38:02 EDT 2013 | arendonk
Hi, We are having issues aluminum wirebonding on ENEPIG plated PCB by a too low pull force and or having lifts (1% range). Could any body advice how to solve this problem? Is there a special wire bond grade required? How to best clean contaminant
Electronics Forum | Wed Sep 11 10:48:02 EDT 2013 | gregp
Hi Reese, The UIC machine is (was) good for higher volumes. Do you think these machines are less appropriate for smaller lot sizes and PCB's with just a few through hole parts? Also, are the UIC through hole machines still fully supported with ampl
Electronics Forum | Thu Sep 12 11:22:58 EDT 2013 | gregp
Wow, great information! I have a feeling you are talking about some predominantly through hole assemblies with mostly common components. In this case fully automated solutions make sense if the volume is there. But these machines cannot do everyth
Electronics Forum | Tue Sep 17 13:58:56 EDT 2013 | smtventasmex
i have a vitronics Delta 6622CC with a software fail, i turn it on and when i open the software on the CPU, it enter but show me a message of wrong vertion, and then i choose ok and software close it self, let me know if some one of you have this fai
Electronics Forum | Wed Sep 18 10:29:22 EDT 2013 | cyber_wolf
Here is what I can tell you... The chemistry we use has adverse reactions with WS fluxes.Vapor degreasing can remove coatings and markings on some components. It can also roach certain types of plastic. On the other hand it works extremely well for r
Electronics Forum | Tue Sep 17 15:40:59 EDT 2013 | 18424
Good day all, I wanted to get a quick poll from the folks running SAC305 in their selective soldering equipment. How are final results? How repeatable is the process, any machine related failures? pumps? nozzles? etc... I am just looking to get a