Electronics Forum | Wed Feb 03 15:29:33 EST 2016 | sarason
Have you ever done QC type thinking on your problem or are you aware o fthe methodology? Do you run your plant in a clean room environment? Do you clean after reflow? If not Why? What sort of products are you running? What sort of oven are we ta
Electronics Forum | Mon Feb 08 08:33:30 EST 2016 | claudea2
Hello, Our EKRA E4 goes off-line after this error message: Application error: SCB16 caused a General Protection Fault in module SBCDRV.EXE at 0011:10DD. Any ideas on how to troubleshoot this? It is running Windows for workgroup 3.11
Electronics Forum | Tue May 03 14:55:50 EDT 2016 | sumote
If it is an ECU you will need power and water. It will keep temp and humidity at your setpoint. I have used them before and was not overly impressed with them. Your process requirements may be more stringent than mine was though. If you have very d
Electronics Forum | Tue May 03 10:58:56 EDT 2016 | ttheis
I'm not sure- I'll check that. The machine is running ups version 3.2.2c. Previously I just went into the order list and selected to move the component in the list, put it at the end before the repair step and added an end block step after the compon
Electronics Forum | Wed May 11 09:07:46 EDT 2016 | SN
We are facing SMT components No solder and solder bridging issue (Glue PCBA) at wave soldering process. Fine tuned the wave parameters improved but not able to eliminate the issue. Suspecting because of moisture pad and component leads contaminated d
Electronics Forum | Wed Jun 22 01:57:28 EDT 2016 | sachinverma
we face the problem to last month dry solder issue.when we found PCB is dry. (PTH not fill not properly)then we change the parameter like flux Tank pressure increase 130 to 250. after these activity PCB is ok no dry solder found......but problem is o
Electronics Forum | Tue Jul 12 10:33:24 EDT 2016 | dontfeedphils
I'd start by checking and reteaching the nozzles (this is automatic, it'll measure the nozzle length and vacuum values for each nozzle). After that double check the value you have entered for the PCB thickness as this will impact where the machine t
Electronics Forum | Wed Jul 20 18:08:35 EDT 2016 | freakshow
any help is much appreciated, I keep getting a random shutdown, sometimes a few minutes sometimes after a few hours. "emergency Stop, Please check the stop button" of course no one is touching the stop button and the button does not seem to be faulty
Electronics Forum | Thu Aug 18 02:39:21 EDT 2016 | epsltd
We have a Mirae 1030 and when the machine warms up the y-axis fails and we are unable to reset servos unless we leave machine powered down few hours. Now since we have changed servos after machine homes we jog the y-axis and it vibrates and very nois
Electronics Forum | Mon Sep 05 16:24:09 EDT 2016 | davef
inspect => conformal coat ... and standards are aligned with that philosophy. I can imagine doing a good job inspecting assembly after being coated with particular coating thickness, optical properties, lighting conditions. Ultra-thins are so thin