Electronics Forum | Mon Jan 03 05:34:16 EST 2011 | jmw
Check in you system configuration that you dont have the opiton to use a matrix tray handler turned on. This is what i have seen cause this problem.
Electronics Forum | Tue Jan 04 16:06:13 EST 2011 | davef
To get started, here's a recent thread about board warp: http://www.smtnet.com/Forums/index.cfm?fuseaction=view_thread&CFApp=1&Thread_ID=15249&mc=7
Electronics Forum | Wed Jan 05 23:46:10 EST 2011 | Shean Dalton
In addition to reducing oxides my understanding is that nitrogen increases the surface tension of solder (I've also read the inverse). Bottom line, Nitrogen reduces rework, improves quality, improves solder appearance, and reduces maintenance. Shea
Electronics Forum | Thu Jan 06 17:20:09 EST 2011 | dyoungquist
Check out this article about nitrogen and soldering: http://www.tequipment.net/pdf/Hakko/TN00000022.pdf
Electronics Forum | Fri Jan 14 16:55:31 EST 2011 | tombstonesmt
On our Pilarhouse Jade we use nitrogen to cool the belt that drives our solder pump as well as keep the amount of oxygen to a minimum in our solder pot to reduce dross.
Electronics Forum | Wed Jan 05 21:22:13 EST 2011 | bajin
Where you are? http://www.esdcoats.net pls check if we are near from you.
Electronics Forum | Thu Jan 06 23:07:48 EST 2011 | essohn
Hello~ I need your expoertised experience. Do you have any experience of Saponifier influence on Al pad for wire bonding. We have a porblem of no wire bonding in use of saponifier in order to remove clean type flux. thanks in advance
Electronics Forum | Sun Jan 09 19:08:18 EST 2011 | essohn
Hi Patrick, Thank you so much for your good advice. I will follow your guideline. Thank you again.
Electronics Forum | Sun Jan 09 23:21:54 EST 2011 | essohn
Hello Patrick, thank syou for your good advice and guideline. I will trto followup your suggestion. Thanks again.
Electronics Forum | Fri Jan 07 10:29:24 EST 2011 | rpatel28364
we are building only 100 units and there is no scrap board available. How can we make sure without distrubing good board that BGA is flowed properly?