Electronics Forum | Thu Feb 23 16:31:09 EST 2012 | hegemon
Could be as simple as a pail full of UR coating and some wire hangars! Conformal coating is brushed on, sprayed on, and parts are dipped too, not to mention the wonderful vacuum process that is paralene. Gotta have a little more info as to your a
Electronics Forum | Wed Feb 29 14:37:14 EST 2012 | hegemon
If I am not mistaken you can buy Spray cans of Conformal Coating. For the small batch in the environment you are describing, that might be the ticket. A bit pricey material wise, but clean up is a cinch. A little masking tape, and spray away!
Electronics Forum | Thu Mar 01 10:35:06 EST 2012 | duso02
For that low a volume it would be simplest and most economical to just out source the work. If you want, just send me an e-mail and I can give you specific options on what would be best for you., in-house or out-house.
Electronics Forum | Fri Mar 02 11:46:18 EST 2012 | cobham1
I like your idea. Can you send me info my email is bill.capen@cobham.com
Electronics Forum | Fri Feb 24 13:21:42 EST 2012 | bobpan
The correct sequence steps should be: 1. tep hold 2-? pick/place/nozzles tep vpass goto 1 This is out of the programming manual.
Electronics Forum | Tue Feb 28 12:23:36 EST 2012 | veeckm
It sounds to me like your using only the Global fiducial mode. If your running multiple images on one panel use image fiducials instead
Electronics Forum | Mon Jan 21 10:21:12 EST 2013 | bobpan
Glad you got it working...if I had worked on them in the last 15 years i might of remembered some of the questions you were asking me a little better. But...hey....its working....thats all that counts.
Electronics Forum | Sun Feb 26 13:01:47 EST 2012 | pdl
Hi guys has any one got a calibration slug for the quad 4c that they can take a picture of and measure it so i can make one. Or even better one that they can sell me. pete@pdl-services.co.uk many thanks Pete
Electronics Forum | Mon Feb 27 15:03:42 EST 2012 | leemeyer
I have the drawings that you need but your email keeps blocking me from sending them.
Electronics Forum | Wed Feb 29 15:01:33 EST 2012 | gosswald
I got one from PPM to set my machine up about two months ago. They had it in stock and I think it was $50.00