Electronics Forum | Thu Apr 19 11:06:16 EDT 2018 | cupet
Hello guys, I am looking for a manual for ersa EWS 500F or EWS 500F XL in electronic format. It would help me to repair the older machine. Peter
Electronics Forum | Fri Jan 17 03:23:14 EST 2014 | aemery
A UP500 Wow! I did work on one last year. Most left out there are labeled QUAD AVX500's, then Speedline bought Sigmaprint and it became a UP500. But you get the MPM sigpro software with the Speedline machine; they didn't build to many. It was used
Electronics Forum | Mon Apr 01 19:12:16 EST 2002 | Mike Konrad
�Cheap� is relevant. Is $ 3,500 for equipment cheap or expensive? If $ 3,500 is cheap, than we have a solution for you. If $ 3,500 is expensive, then purchase pre-saturated chemical wipes, latex gloves and a hazardous waste bin. As for �effective
Electronics Forum | Mon Jun 13 16:15:04 EDT 2005 | peter ng
Dear all, We faced some major issue in setting our company target to 500 points per million at machine throw rate.It might be caused by human error,machine,feeder,environment or other factor.We need some opition and advise on how to achieve this targ
Electronics Forum | Mon Jun 13 16:17:30 EDT 2005 | peter ng
Dear all, We faced some major issue in setting our company target to 500 points per million at machine throw rate.It might be caused by human error,machine,feeder,environment or other factor.We need some opition and advise on how to achieve this targ
Electronics Forum | Sat Sep 05 23:15:32 EDT 2009 | prasadz
We have successfully implemented this dual Process You can use any printer that supports Board width 500mm. SMT Dual Process Maximum PCB Width should be (500-20 / 2 ) = 240mm Max (PCB width )Printer support = 500mm Top width + Bottom width
Electronics Forum | Wed Aug 31 17:12:23 EDT 2016 | ttheis
Yeah, it's set to use SMEMA for down line. I have the conveyor conected to downline fmi on up500 (right side of machine,) but the Upline Ready light is activated on the up500 when the conveyor is ready and not the downline like I would expect to see.
Electronics Forum | Fri Feb 02 11:26:16 EST 2001 | dason_c
Any comment on the solder pot temperature setting, 500F (260C) or 482F (250C). Most of the manufacturer is using 500F in CA. Rgds. Dason