Electronics Forum | Wed Mar 02 02:22:09 EST 2016 | akon63
hey dude you can find the manual for the conveyor belt fluid cleaner here http://www.orf.ae/ as a professionals i believe they would be more than happy to help you
Electronics Forum | Fri Nov 19 10:56:20 EST 2004 | rlackey
Hi Mike, We mainly use chillers for the operators - we build a lot of thick & palletised boards that retain the heat. Having a chiller means we can pick the board up earlier after the oven & it's cooler. With leadfree you will have higher temperat
Electronics Forum | Tue Jan 11 17:19:15 EST 2005 | vickt
Clark, Which component type are you using? Deform? also, is this a domed led? and if so, are you using a nozzle with an approriate ID to seal on the body? Not every LED may be able to be placed with a 4791. Todd
Electronics Forum | Tue Jan 18 11:47:10 EST 2005 | clarkk
JB, I've toggled between front and back lighting and the results are about the same. But thanks anyway for the suggestion. Clarkk
Electronics Forum | Thu Mar 01 14:35:52 EST 2012 | edmneb
We recently got a used Electrovert Bravo 8105 in house, but the unit did not come with any passwords to access the software. Any one know a default password, or way to change the passwords? Thanks!
Electronics Forum | Thu Jan 13 17:45:24 EST 2005 | vickt
Clark, As a start....Do you have a qualified tech on site to verify that the camera lighting is within spec? If not it's hard to say where you are starting from. I know that UIC still has trained personel that can help you out on this older gear if y
Electronics Forum | Tue Jan 18 11:11:02 EST 2005 | JB
I don't think the light levels can be adjusted manually. Two options that I know of, back ltg and front ltg. If you have auto teach mode, switch between this two. If the bottom is clear use back ltg on a square mold. Hope it helps.
Electronics Forum | Tue Dec 21 13:27:47 EST 1999 | Vince Whipple
Charlie: As far as setting up a spray fluxer.. Are you spraying no-clean, voc free, water soluble? What you would want to do is to run a blank pcb through the fluxer and pop it out before the preheaters. Visually inspect for variations in uniformit
Electronics Forum | Tue Jan 11 11:08:03 EST 2005 | clarkk
Hello, We are assembling a large pcb with 256 Lumex #SSL-LXA228SRC-TR31 SMT LED's on an HSP 4791. The part I'm using for the library is a modification of an existing SMT LED from the standard library. The problem is that the HSP rejects about 30% of
Electronics Forum | Thu Jan 13 15:58:50 EST 2005 | clarkk
Vikt, I'm using the LED type (leaded form). The LED is domed, but the dome is on the bottom. The surface that the nozzle picks up on is flat, and the nozzle does not extend beyond the edge of the body. The problem is in the inspection, which is rejec