Electronics Forum | Mon Jun 04 09:20:38 EDT 2018 | dekhead
>> mis-alignment?
Electronics Forum | Wed Sep 04 12:02:03 EDT 2019 | spinn
Hi all, Just to add further information to this post. We have 10 inch (250mm)and 19 inch (480mm) Dek 248 complete printer squeegee clamps with blades. On the 250mm one blade has a very slight kink though shouldnt cause a problem. Offers welcome
Electronics Forum | Mon Jul 16 09:15:57 EDT 2018 | bukas
problem was solved by cleaning lid bolt connector on chassis... both lid bolt and chase clamps are controlled by SCB34 card, it seams that there is an issue with poor connection on lid bolt triggering this bug. I assume its bug because other card beh
Electronics Forum | Tue Aug 29 14:21:24 EDT 2006 | billyd
Dude: I have used the Grid-lok system before, in DEK 265 and DEK Infinity printers (clamps) and they worked quite well. But, we did have the side clamps. I'm not sure how that translates to an MPM. They were the best we could find as far as the
Electronics Forum | Tue May 29 08:37:52 EDT 2018 | bukas
screen alignment chase clamp state is ON, it can be turned OFF but when I get out of diagnostics machine turns them ON again. Tooling is set to magnetic, and on other machines I have chase clamps are not energized all until board is in machine and st
Electronics Forum | Tue Aug 29 21:14:45 EDT 2006 | Bubba
You need a machine with side clamps. DEK makes them. MPM makes them. Look into a retro for your machine. Both take up space on top of your board. Be carefull of top side component clerance if switching.
Electronics Forum | Wed Feb 14 23:56:06 EST 2024 | jborrelli76
We have a DEK Horizon 05 with stencil clamps operational on left side only, right side non-opertional. Any ideas where to get started troubleshooting?
Electronics Forum | Mon Jun 04 09:59:03 EDT 2018 | bukas
correct, I also tried swapping motherboard but still same result. i the mean time i found battery leakage on Eurosys X1, replaced battery but now it won't start communication on machine initialization. got to repair it or something...
Electronics Forum | Mon Jun 04 10:16:29 EDT 2018 | dekhead
I have seen battery leakage damage traces on MINT cards... Since you indicate failure on machine initialization, assume you are able to communicate / accomplish MINT download. (?)
Electronics Forum | Tue Jun 05 07:30:13 EDT 2018 | bukas
sadly no, I can't open cmd since system doesn't come up, segment display on card shows .L and 8 blinking
